110060007 Seeed Studio

Rainbow Cube Assembly Guide 1.8mm RGB LED x70 2.Cube Panel X1 3.Slim Panel PCB X4 4.Side A slim PCB X4 5.Side B slim PCB X4 6.2.54mm 40pin male header X5 7.2.54mm 40pin femail header 8.2.54mm 16pin female header 9.2.0mm 10pin female header X2 X2 X3 12.JST power cable X1 10.8pin female header X5 11.2X3 female header X1 13.3.5mm 4pin green terminal X1 14.3.5mm DC jack X1 15.3mm LED red X1 16.3mm LED green X1 17.1K 1/8w resistor X4 18.10k 1/8w resistor X1 19.15k 1/8w resistor X1 20. linear voltage regulator X1 21.10uF 16v E-CAP X2 Before starting build your cube, please read though all the instructions rst. Bulding the Cube is not dif cult, but it will take your about 90 minutes to nish it. Building the Cube. LED Soldering Find the bag included 70 RGB LEDs and 4 Slim Panel PCBs, hold one LED, lines up the pins and push it in. The longest pin of LED needs to lines up to the square though hole on PCB,(Marked red). Notice the at spots about 5mm away from the LED, stop pushing the LED in when the at spots reached the PCB. Please note that the LED pins need to line up to silk screen. Repeat doing this, fill all 4 slim panel PCBs with LEDs, solder them and clip off the extra wires. Tips: It s recommended to set the iron temperature at 350 centi degree, or you might burn the LEDs. Side A slim PCB