DC100D10 Sensata

Panel Mount Datasheet Power Plus DC Series Ratings from 10 A to 100 A 100 VDC Mosfet Output LED Status Indicator DC control Relays are easily paralleled for higher-current EMC Compliant to Level 3 applications Epoxy Free Design UL Approved, CE Compliant to EN60950-1 Optional IP20 Cover Improved SEMS screw and washer PWM to 1K Hz Redesigned housing with anti-rotation barriers For Generation 3 datasheet click here PRODUCT SELECTION Control Voltage 10 A 20 A 40 A 60 A 80 A 100 A 4-32 VDC DC100D10 DC100D20 DC100D40 DC100D60 DC100D80 DC100D100 AVAILABLE OPTIONS Termination Blank: Screws & clamps Control Voltage K: Installed standoffs with (1) Thermal Pad D: 4-32 VDC screws for PC Board Blank: Not Included Series mounting (IP00 only) H: Included DC 100 D 40 K C H Operating Voltage Cover Rated Load Current 100: 1-100 VDC 10: 10 Amps Blank: Not Included (IP00) 20: 20 Amps C: Included (IP20) Required for valid part number 40: 40 Amps For options only and not required for valid part number 60: 60 Amps Not all part number combinations are available. * 80: 80 Amps Contact Crydom Technical Support for information on 100: 100 Amps the availability of a specific part number. (2) OUTPUT SPECIFICATIONS Description 10 A 20 A 40 A 60 A 80 A 100 A Recommended Operating Voltage Vdc 1-72 1-72 1-72 1-72 1-72 1-72 Absolute Maximing Rating Vdc 100 100 100 100 100 100 Maximum Off-State Leakage Current Rated Voltage mA 0.1 0.1 0.1 0.1 0.1 0.1 Maximum Load Current Adc (1)(3) 10 20 40 60 80 100 Minimum Load Current mA (4) 2.5 2.5 2.5 2.5 2.5 2.5 Maximum Surge Current (10msec) Adc 66 91 136 180 220 330 Maximum On-State Voltage Drop Rated Current Vdc 0.13 0.24 0.28 0.36 0.40 0.4 Maximum On-State Resistance RDS-ON m 13 12 7 6 5 4 Thermal Resistance Junction to Case (Rjc) C/W 1.27 0.73 0.58 0.45 0.34 0.27 Minimum Heat Sink for Rated Current 40C C/W N/R 5 2 1 0.5 0.5 Maximum Pulse Width Modulation Frequency Hz (5) 1000 1000 900 900 700 700 (2) INPUT SPECIFICATIONS Description DC Control Control Voltage Range 4-32 VDC Maximum Reverse Voltage -32 VDC Minimum Turn-On Voltage (6) 4 VDC Must Turn-Off Voltage 1 VDC Minimum Input Current (for on-state) 11 mA Maximum Input Current 14 mA Nominal Input Impedance Current Regulated Maximum Turn-On Time sec 75 Maximum Turn-Off Time sec 150 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright 2020 Crydom Inc. Specifications subject to change without notice.Panel Mount Datasheet (2) GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) 3750 Vrms 9 Minimum Insulation Resistance ( 500 VDC) 10 Ohms Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range (7) -40 to 100 C Ambient Storage Temperature Range -40 to 125 C Weight (typical) 2.53 oz (72 g) Housing Material UL94 V-0 Hardware Finish Nickel Plating Baseplate Material Aluminum Input Terminal Screw Torque Range (in-lb/Nm) 13-15 /1.5-1.7 Load Terminal Screw Torque Range (in-lb/Nm) 18-20 / 2-2.2 SSR Mounting Screw Torque Range (in-lb/Nm) 18-20 / 2-2.2 Input/Load Terminal Screw Torque Range (in-lb/Nm) (1) w/K option 8-10 / 0.9-1.13 Input/Output Terminal Screw Thread Size 6-32 UNC / 8-32 UNC Humidity per IEC60068-2-78 85% non-condensing LED Input Status Indicator Green 21,395,130 hours (2,441 years) MTBF (Mean Time Between Failures) at 40C ambient temperature (8) 11,545,504 hours (1,317 years) MTBF (Mean Time Between Failures) at 60C ambient temperature (8) WIRING DIAGRAM * Inductive loads must be diode suppresed. + + - V * * V Load Load - + + Recommended Wire Sizes Wire Size Wire Pull-Out Terminals (Solid / Stranded) Strength (lb) N 2 24 AWG (0.2 mm ) / 0.2 minimum 10 44.5 Input +2 +2 1 OUTPUT 1 OUTPUT 2 2 x 12 AWG (3.3 mm ) / 3.3 maximum 90 400 S OL I D S T A T E R EL A Y S OL I D S T A T E R EL A Y 2 20 AWG (0.5 mm ) / 0.518 minimum 30 133 4 INPUT +3 4 INPUT +3 Output 2 2 x 10 AWG (5.3 mm ) / 5.3 110 490 2 2 x 8 AWG (8.4 mm ) / 8.4 maximum 90 400 + + V V - - EQUIVALENT CIRCUIT BLOCK DIAGRAMS Input Current vs Input Voltage Standard Regulated DC Input 14 33 22 +DC +DC 12 10 Control Trigger Circuit Circuit 8 6 4 -DC 44 11 -DC 2 Current Limiter 0 0 5 10 15 20 25 30 35 DC Input Voltage Do not forget to visit us at: www.crydom.com Copyright 2020 Crydom Inc. Specifications subject to change without notice. INPUT OUTPUT Input Current (mA)