DO061A-B Sensata

PCB Mount DataSheet DO Series Mini-SIP SSR Ratings to 1A 60 V DC Bi-polar transistor output DC control Normally open or normally closed output PRODUCT SELECTION Control Voltage 1 A 3-9 VDC DO061A , DO061A-B 1.7-9 VDC DO061B , DO061B-B AVAILABLE OPTIONS Output Type Blank: Normally Open Load Current -B: Normally Closed 061: 1 Amp A -B DO 061 Series Control Range DO: Bipolar A: 3-9 VDC Transistor Output B: 1.7-9 VDC Required for valid part number For options only and not required for valid part number (1) OUTPUT SPECIFICATIONS Description DO0 Operating Voltage (47-63Hz) Vrms 3-60 Maximum Off-State Leakage Current Rated Voltage A 200 Maximum Load Current Adc 1.0 Minimum Load Current Adc 0.02 Maximum Surge Current Adc 5 (1sec) Maximum On-State Voltage Drop Rated Current (2) 1.5 Minimum Power Factor (with Maximum Load) 0.5 (1) INPUT SPECIFICATIONS Description DO061A DO061B Control Voltage Range 1.7-9 VDC 3-9 VDC Must Turn On Voltage 3.0 VDC 1.7 VDC Must Turn Off Voltage 1.0 VDC 0.8 VDC Typical Input Current 5 VDC 15 mAdc 15 mAdc Nominal Input Impedance 1800 Ohm 270 Ohm Maximum Turn-On Time sec 50 50 Maximum Turn-Off Time sec 50 150 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice.+DC -DC +DC -DC PCB MouPCB Mount nt DataSheetDataSheet GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) (3) 4000 Vrms 9 Minimum Insulation Resistance ( 500 VDC) (3) 10 Ohm 8 pF Maximum Capacitance, Input/Output -30 to 80C Ambient Operating Temperature Range -30 to 125C Ambient Storage Temperature Range 0.15 oz. (4.3g) Weight (typical) Thermally Conductive Epoxy Encapsulation GENERAL NOTES (1) All parameters at 25C unless otherwise specied. (2) Typical On-State Resistance=0.13 ohms (3) Dielectric and insulation resistance are measured between input and output (4) Inductive loads should be diode suppressed MECHANICAL SPECIFICATIONS Tolerances: 0.02 in / 0.5 mm Wiring Diagram (4) All dimensions are in: inches millimeters DC CONTROL PIN 1: +DC LOAD PIN 2: -DC LOAD PIN 3: +DC CONTROL PIN 4: -DC CONTROL THERMAL DERATE INFORMATION 1.0 0.8 0.6 0.4 0.2 0 20 40 60 80 Ambient Temperature (C) Max. Load Current vs. Temp. AGENCY APPROVALS AGENCY APPROVALS Rev. 101317 ECN 20337 Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice. LOAD 1 LOAD 2 CONTROL CIRCUIT 3 4 Load Current (Amps) + +