FSHPLC Flow switch for connection to PLC Signal level output for PLC 20 l/min turn on flow rate Automatic shut down on flow stop Volt free contact for output to PLC 1BSP pipe connections Technical Specification Screw mount Material Brass Enclosure material Polyamide Enclosure rating IP54 Start up flow rate Q. min l/min 20 Max Pressure P max bar 10 Max Temperature T max C 100 Pipe connections BSP 1 Electrical Specification Output SPNO volt free contact Max voltage Vac <5 Switching Current Max mA <1 Standard Parts On flow rate FSH10PLC 20 l/min The FSHPLC can be used to control some other equipment or process via a PLC. It could be for controlling a circulating or centrifugal electric pump that is providing 95 increased pressure or flow within water systems with storage tanks. The FSHPLC switches the output, once the flow rate through the pipe exceeds 20 l/min. 94 A flow of less than 20 l/min, whether due to a lack of supply (e.g. tank empty) or to a decrease in demand(e.g. tap closing), will turn the output off again. 22 113 Cynergy3 Components Ltd. 7 Cobham Road Ferndown Industrial Estate Wimborne, Dorset BH21 7PE Telephone +44 (0) 1202 897969 Email:sales cynergy3.com ISO9001 CERTIFIED www.cynergy3.com 2014 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.FSHPLC Flow switch for connection to PLC Installation information The flow switch is designed to be used in a horizontal pipe with the switch mounted through a side entry. Pipe connection is G1 (1BSP). The device relies on the flow of liquid working in opposition to the spring loaded paddle. The liquid flow moves the paddle within the pipe, when the G1 socket connection flow increases beyond the minimum specified level. A magnet mounted on the head of the paddle closes a magnetic switch in the control circuit. The output switch will open, if the flow drops below the specified level and the paddle has returned to the rest position. Flow Direction The output is a SPNO switch with contacts rated to 1mA/5Vac. G1 - G4 pipe size G1 mounting thread o ring seal Adaptor ring o ring seal Cynergy3 Components Ltd. 7 Cobham Road Ferndown Industrial Estate Wimborne, Dorset BH21 7PE Telephone +44 (0) 1202 897969 Email:sales cynergy3.com ISO9001 CERTIFIED www.cynergy3.com 2012 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.