LSE240D8 Sensata

PCB Mount DataSheet LS Series SIP SSR Ratings to 12A 280 VAC SCR output for heavy industrial loads DC control Zero Voltage Turn-on (resistive loads) or Instantenous Turn-on (inductive loads) output PRODUCT SELECTION Control Voltage 8A 12A 4-10 VDC LS240D8 LS240D12 20-28 VDC LSE240D8 LSE240D12 AVAILABLE OPTIONS Operational Current Operational Voltage 8: 8 Amps 240: 24-280 VAC 12: 12 Amps Series LS E 240 D 12 R Control Voltage Control Input Voltage Switching Type Blank: 4-10 VDC D: DC Input Blank: Zero Voltage Turn-On E: 20-28 VDC R: Instantaneous Turn-On Required for valid part number For options only and not required for valid part number (1) OUTPUT SPECIFICATIONS Description LS240D8 LS240D12 Operating Voltage (47-63Hz) Vrms 24-280 24-280 Transient Overvoltage Vpk 600 600 Maximum Off-State Leakage Current Rated Voltage mArms 0.1 0.1 Minimum Off-State dv/dt Maximum Rated Voltage V/sec (2) 500 500 Maximum Load Current Arms (3) 8 12 Minimum Load Current Arms 0.15 0.15 Maximum Surge Current (16.6ms) Apk 80 120 Maximum On-State Voltage Drop Rated Current Vpk 1.6 1.6 Thermal Resistance Junction to Case (Rjc) C/W 2.2 2.0 Minimum Power Factor (with Maximum Load) 0.5 0.5 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice.PCB Mount DataSheet (1) INPUT SPECIFICATIONS Description LS LSE Control Voltage Range 4-10 VDC 20-28 VDC Must Turn On Voltage 4.0 VDC 20 VDC Must Turn Off Voltage 1.0 VDC 1.0 VDC Typical Input Current Nominal Voltage 15 mA 15 mA Nominal Input Impedance 270 Ohm 1500 Ohm Maximum Turn-on Time msec 1/2 Cycle 1/2 Cycle 1/2 Cycle Maximum Turn-Off Time msec 1/2 Cycle (1) GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) 2500 Vrms 9 10 Ohm Minimum Insulation Resistance ( 500 VDC) Maximum Capacitance, Input/Output 10 pF Ambient Operating Temperature Range -30 to 80 C Ambient Storage Temperature Range -30 to 125 C Weight (typical) 0.6 oz. (17 gr) Encapsulation Thermally Conductive Epoxy GENERAL NOTES (1) All parameters at 25C and per section unless otherwise specied. (2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 (3) See Current Derating Curve. WIRING DIAGRAM -VDC 4 +VDC 3V B LOAD VAC 2 Load can be used wired in position A or B LOAD VAC 1 A Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice. Trigger Circuit