SI5XX-EVB Silicon Labs

Si5xx-EVB Si5XX SINGLE/DUAL FREQUENCY XO/VCXO EVALUATION BOARD Description The Skyworks Si5xx evaluation board contains the hardware needed for evaluation of the Si5xx Single/Dual Frequency XO/VCXO. Note: The Si5xx-EVB is not populated with an Si5xx XO or VCXO. These devices must be ordered separately. Go to www.skyworksinc.com/en/application-pages/timing-lookup-customize to configure a device and/or to order samples. Features Evaluation of Skyworks Si5xx Single/Dual Frequency XO/VCXO Voltage control (VC) input port (Si515, Si516) Supports frequencies up to 1.4 GHz (using Si53x/55x) Dual footprint supports 3.2 x 5 or 5 x 7 mm Function Block Diagram J1 Power In 6 (4) VDD J12 J3 1 (1) 4 (3) NC/FS/VC/OE CLKP CLKP Output VCO input Filter Conditioner 5 2 NC/FS/OE CLKN CLKN J2 GND 3 (2) Note: pin numbers in parentheses represent pin numbers for the 4-pin device J4 J5 Skyworks Solutions, Inc. Phone 781 376-3000 Fax 781 376-3100 sales skyworksinc.com www.skyworksinc.com Rev. 0.2 Skyworks Proprietary Information Products and Product Information are Subject to Change Without Notice October 17, 2021Si5xx-EVB 1. Introduction This document describes the operation of the Skyworks Si5xx evaluation kit. The Si5xx-EVB kit refers to the evaluation board hardware intended for customer evaluation of the Si5xx single/dual frequency XO/VCXO. The Si5xx-EVB kit contains the following: Si5xx-EVB Hardware Si5xx-EVB User Guide (this document) The Si5xx-EVB evaluation board can be used to evaluate all the single and dual frequency Si5xx XO/VCXOs offered by Skyworks: Table 1. Si5xx XO and VCXO Device Evaluation Board Selector Guide Part Type Devices Packages Supported Output Format, Supported Supported Temp Stability, Frequency Tuning Slope Range Si5XX-EVB Fixed Frequency Si510/511 5 x 7 mm, 6-pin LVPECL 100 kHz to XO/VCXO Si512/513 3.2 x 5 mm, 6-pin CML HCSL 1417 MHz Eval Board Si515/516 3.2 x 5 mm, 4-pin LVDS CMOS Si530/531 Dual-CMOS Si532/533 Si535/536 Si550/552 Si590/591 Note: Si5xx samples must be ordered separately from the Si5xx-EVB. 1.1. Quick Start 1. Install an Si5xx device on the board. 2. Verify the jumper settings are correct. 3. Connect external power cable to the EVB (set voltage according to how the part was ordered). 2. Top/Bottom Views of Board Figure 1. Top (Left) and Bottom (Right) Board Views 2 Skyworks Solutions, Inc. Phone 781 376-3000 Fax 781 376-3100 sales skyworksinc.com www.skyworksinc.com Rev. 0.2 Skyworks Proprietary Information Products and Product Information are Subject to Change Without Notice October 17, 2021