UG177: TS4100-01-02 EVB User s Guide The TS410x series of multiplexers offer no compromise performance for the best signal KEY FEATURES integrity, simple design, and low power operation as they can operate at a supply volt- age as low as 0.8 V while accepting an input signal swing above the supply voltage up TS4100: 1x 8 Channel Multiplexer to 5.25 V Rail-to-Rail Plu). Additionally, the on-resistance variation over the entire TS4101: 2x 4 Channel Multiplexer signal swing range is less than 1%, exhibiting excellent linearity and consistency in dy- namic and measurement applications. The evaluation boards are simple to use and al- TS4102: 3x Single-pole/Double-throw Switch (SPDT) low quick evaluation of the performance of the multiplexers. The board is configured for testing all eight channels, NO0-NO7, or all three single-pole/ double-throw switches with a dc input voltage derived from V . Jumper INH is available DD to turn all switches OFF. Jumper A, B, and C is available to select an input, NC or NO. These switches are fully specified over the -40 C to +85 C temperature range and are available in a low-profile, thermally-enhanced 16-pin 3x3 mm TQFN package with an ex- posed back-side paddle. silabs.com Smart. Connected. Energy-friendly. Rev. 0.1 UG177: TS4100-01-02 EVB User s Guide Procedure Description 1. Procedure Description 1.1 TS4100DB Quick Start Procedure Table 1.1. TS4100DB Address Bits INH ADDRESS BITS COM A B C Output 1 X X X GND 0 0 0 0 NO0 0 0 0 1 NO1 0 0 1 0 NO2 0 0 1 1 NO3 0 1 0 0 NO4 0 1 0 1 NO5 0 1 1 0 NO6 0 1 1 1 NO7 The TS4100 demo board is configured with a COM output resistor and capacitor load of 1 k and 10 pF. The TS4100 operates at a supply voltage range of 0.8 V to 5.25 V and an analog input/outputRail-to-Rail Plu range of 0 V to 5.25 V. The TS4100 can be tested with an on-board dc input signal or an external ac input signal. The on-board voltage is generated via a voltage divider circuit. The complete demo board circuit is shown in Figure 2.1 TS4100DB Schematic on page 6. To select a channel or turn OFF all channels, jumper A, B, C, and INH can be set according to the table above. silabs.com Smart. Connected. Energy-friendly. Rev. 0.1 1