CENT1120
Universal 120 Watt Series
ITE Switch-Mode Power Supply 3 Year Warranty
Universal Input 100Vac 240Vac
Single Output Models up to 120W
Desktop Style/Non-vented case
Efficiency Level IV
Power Factor Correction
Certified to UL/ EN60950
IPX1 Rated Enclosure
Complies with EMI/RFI Regulations
Modified and Custom Designs Available
Specifications
Specifications
AC Input 90-264Vac, 47-63 Hz single phase MTBF > 100K hours (calculated, 25C at full load)
Input Current 90VAC: 2A, 180VAC: 1.0A Hold-up Time 16.7 ms min. @ 110VAC
Inrush Current Inrush Current Protection Provided Overvoltage Protection Latching
Input Fuse Internal Primary Current Fuse Provided Overload Protection >120% of full rated load, Hiccup Mode
Earth Leakage Current Input-GND: <3.5mA, Normal State Short Circuit Protection Hiccup Mode, auto-recovery
Output-GND: <0.25mA, Normal State
Efficiency 88% typical Overtemperature Protection Latching
No Load Power <0.5W Output Voltage See chart
Input Harmonics Meets IEC61000-3-2, class D Safety Standards IEC/EN/UL60950
Transient Response 5ms return to within 1%, 50% load step. Topology Two-Stage Conversion and Quasi-Resonant Flyback
0.2A/sec slew rate. Maximum deviation is 5%
Line/ Load Voltage Regulation Line: +/-2.0% max., Load: +/-5% max Isolation Input-Output: 3000VAC,
Input-GND: 1500VAC, Output-GND: 500VDC
Minimum Load Not required Operating Temperature 0 to 40C with no derating
Ripple and Noise 1% pk-pk max., 20MHz BW, differential mode Temperature Coefficient 0.3% per C, maximum
Turn-on Time 3 sec. maximum @ 115VAC
Storage Temperature -20C to +85C
Case Material Black 94V-0 rated Polycarbonate Relative Humidity 5% to 95%, non-condensing
Case Dimensions/Output Connections See chart and outline drawing Altitude 0 to 10,000 ft, operating; -500 to 40,000 ft, non-operating
Model Number Key
CENT 1 120 A VV 51 F 01
Model01" = Standard. 02" and higher indicates a modified model.
Input Connector: = IEC320 C14 grounded, Other options available, see below
Output Connector:51" = 6 pin Molex. Other options available.
Output Voltage:09" = 9Vdc,12" = 12Vdc,24" = 24Vdc, etc.
Model = Original Configuration
Output Power:120" = 120 Watts
# of Outputs1" = Single Output
Product Family: = Commercial/ITE/Industrial, = External,N = New Technology
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp 6050 King Drive Ventura, CA 93003 Phone 805.486.4565 Fax 858.712.2040 Email: info@slpower.com www.slpower.com
CENT1120
Universal 120W Series
ITE Switch-Mode Power Supply 3Year Warranty
OUTPUT PARAMETERS
Model Number Output Volts Output Current (max) Max Watts Ripple (Vp-p max)
CENT1120A0951F01 9V 9.00A 81W 90mV
CENT1120A1251F01 12V 9.17 A 120W 120mV
CENT1120A1551F01 15V 7.33 A 120W 150mV
CENT1120A1851F01 18V 6.67 A 120W 180mV
CENT1120A2451F01 24V 5.00 A 120W 240mV
CENT1120A4851F01 48V 2.50 A 120W 480mV
Note: Ripple and Noise is measured with 0.1F ceramic and 10F electrolytic capacitor in parallel, connected at the measurement point.
EMI/EMC Compliance
Conducted Emissions EN55022 Class B
Radiated Emissions
EN55022 Class B, FCC Part 15, Class B.
Static Discharge Immunity EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz..
Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity EN61000-4-8, 3A/m, performance criteria A
Voltage Dip Immunity EN61000-4-11, 70% UT for 10mS, 40% UT for 100mS, <5% UT
for 5000mS, performance criteria A, B
Line Flicker EN61000-3-3
Line Frequency Harmonics EN61000-3-2, Class D
Input Receptacle Output Connector (12V model) Output Connector (All other models)
IEC320, C14 Class I #3 Connector is 2.5mm barrel type, center (+) #51 Connector is Molex 39-01-2060 or equivalent.
Outline Drawing (#51 connector shown)
167
(6.6)
82
(3.2)
1800+/- 50mm
(1000mm on 12V models)
40
(1.6)
Data Sheet 2010 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 12-3-2010
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp 6050 King Drive Ventura, CA 93003 Phone 805.486.4565 Fax 858.712.2040 Email: info@slpower.com www.slpower.com