EV-VN7E010AJ STMicroelectronics

EV-VN7E010AJ Data brief VN7E010AJ evaluation board Features V Max transient supply voltage 40 V CC V Operating voltage range 4 to 28 V CC R Typ. on-state resistance (per Ch) 10.5 m ON Current limitation (typ) I 88 A LIMH Stand-by current (max) I 0.5 A STBY Minimum cranking supply voltage (V decreasing) V 2.85 V CC USD cranking Simple single IC application board dedicated for VN7E010AJ Provides electrical connectivity and thermal heat-sinking for easy prototyping General device features Extreme low voltage operation for deep cold cranking applications (compliant to LV124, revision 2013) Single channel smart high-side driver with CurrentSense analog feedback Very low standby current Compatible with 3 V and 5 V CMOS outputs Diagnostic functions Analog feedback of load current with high precision proportional current mirror Overload and short to ground (power limitation) indication Thermal shutdown indication Product status link OFF-state open-load detection EV-VN7E010AJ Output short to V detection CC Sense enable/disable Product summary Protections VN7E010AJ Undervoltage shutdown EV-VN7E010AJ evaluation board Overvoltage clamp Load current limitation Self limiting of fast thermal transients Configurable latch-off on overtemperature or power limitation with dedicated fault reset pin Loss of ground and loss of V CC Reverse battery with external components Electrostatic discharge protection Applications Automotive resistive, inductive and capacitive loads Protected supply for ADAS systems: radars and sensors Automotive headlamp DB4002 - Rev 1 - September 2019 www.st.com For further information contact your local STMicroelectronics sales office.EV-VN7E010AJ Description 1 Description This board provides you an easy way to connect STMicroelectronics VIPower M0-7 technology into your existing system. The board comes pre-assembled with VN7E010AJ high-side driver. On board minimum set of electrical components (as for device datasheet recommendation) is enabling the user to directly connect the load, the power supply and the microcontroller without any additional effort in external component design and connection. The VN7E010AJ is a single channel high-side driver manufactured using ST proprietary VIPower technology and housed in PowerSSO-16 package. The device is designed to drive 12 V automotive grounded loads through a 3 V and 5 V CMOS-compatible interface, providing protection and diagnostics. The device integrates advanced protective functions such as load current limitation, overload active management by power limitation and overtemperature shutdown with configurable latch-off. A FaultRST pin unlatches the output in case of fault or disables the latch-off functionality. A dedicated multifunction multiplexed analog output pin delivers sophisticated diagnostic functions including high precision proportional load current sense, supply voltage feedback and chip temperature sense, in addition to the detection of overload and short circuit to ground, short to VCC and OFF-state open-load. A sense enable pin allows OFF-state diagnosis to be disabled during the module low-power mode as well as external sense resistor sharing among similar devices. Figure 1. Evaluation board schematic In PullUP FaultRST CurrentSense CurrentSense CurrentSense S EN SEL 0 SEL 1 IN GAPG300820191223MT DB4002 - Rev 1 page 2/7