ISP1302UKTS STMicroelectronics

ISP1302UK USB On-The-Go transceiver Rev. 03 29 September 2009 Product data sheet 1. General description The ISP1302UK is a Universal Serial Bus (USB) On-The-Go (OTG) transceiver device. It is fully compliant with Universal Serial Bus Specification Rev. 2.0 and On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3. The ISP1302UK can transmit and receive serial data at full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s) data rates. The ISP1302UK is available in WLCSP25 package. 2. Features Fully complies with: Universal Serial Bus Specification Rev. 2.0 On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3 On-The-Go Transceiver Specification (CEA-2011) Can transmit and receive serial data at full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s) data rates Supports OTG Host Negotiation Protocol (HNP) and Session Request Protocol (SRP) 2 Supports I C-bus (up to 400 kHz) serial interface to access control and status registers Supports Universal Asynchronous Receiver-Transmitter (UART) pass-through on the DP and DM lines Supports service mode with 2.8 V UART signaling on the DP and DM lines Built-in charge pump regulator outputs 5 V at current up to 50 mA 3.0 V to 4.5 V power supply input range (V ) CC Supports wide range digital interfacing I/O voltage (V ) 1.4 V to 3.6 V CC(I/O) Full industrial grade operation from 40 C to +85 C Available in small WLCSP25 halogen-free and lead-free package 3. Applications Mobile phones Digital camera Personal digital assistantISP1302UK USB OTG transceiver 4. Ordering information Table 1. Ordering information Commercial Package description Packing Minimum sellable product code quantity ISP1302UKTS WLCSP25 25 bumps 2.5 2.5 0.6 mm 7 inch tape and reel non-dry pack 3000 pieces ISP1302UK 3 ST-ERICSSON 2009. All rights reserved. Product data sheet Rev. 03 29 September 2009 2 of 49