STEVAL-IFP016V2 IO-Link communication master transceiver demonstration board based on the L6360, monolithic IO-Link master port Data brief Features Supply voltage from 18 V to 32.5 V Fully protected programmable output stages Supports COM1, COM2 and COM3 mode 5 mA IO-Link digital input Additional IEC61131-2 type-1 input 3.3 V / 5 V, 50 mA linear regulator 2 Fast mode I C for IC control, configuration and diagnostic Diagnostic dual LED sequence generator and driver 5 V and 3.3 V compatible I/Os The interface is compatible with the STEVAL- Interface compatible with STEVAL-PCC009V2 PCC009V2 and STEVAL-PCC009V1 EMC- and STEVAL-PCC009V1 immune application against ESD, burst, surge, RF EMC immune application against ESD, burst, noise, etc., according to IEC61000-4-2, surge, RF noise, etc., according to IEC61000- IEC61000-4-4, IEC61000-4-5, and IEC61000-4-6 4-2, IEC61000-4-4, IEC61000-4-5, and standards. IEC61000-4-6 standards A large GND area on the printed circuit board has RoHS compliant been designed in order to minimize noise and ensure good thermal performance. Description The small size of the L6360 package with a The STEVAL-IFP016V2 IO-Link communication reduced pin number, along with the small size of master transceiver demonstration board is based the application area, allow the user to work in on the L6360, monolithic IO-Link master port. A applications where space constraint is critical. modular and customizable application that The L6360 is a monolithic IO-Link master port, interfaces externally with the microcontroller. The compliant with PHY2 (3 wires) supporting COM1 purpose of the board is to demonstrate the (4.8 kbaud), COM2 (38.4 kbaud) and COM3 capability of the L6360 monolithic IO-Link master, (230.4 kbaud) modes. The output stage (high- as communication transceiver for multiple I/Os. side, low-side or push-pull) as well as the cutoff current, cutoff current delay time, and restart The board uses input signal from the 2 delay, are programmable by I C protocol. microcontroller and outputs the 24 V required for industrial applications. The cutoff current and cutoff current delay time, combined with the thermal shutdown and The board demonstrates that the L6360 is both automatic restart, protect the device against IO-Link master port mode and standard IO mode overload and short-circuit. The output stages are compliant. able to drive resistive, inductive and capacitive loads. Fast demagnetization is able to dissipate the energy stored in the inductive loads. September 2012 Doc ID 023081 Rev 2 1/4 For further information contact your local STMicroelectronics sales office. www.st.com 4Schematic diagram STEVAL-IFP016V2 1 Schematic diagram Figure 1. Schematic diagram - V 2/4 Doc ID 023081 Rev 2