ST-LINKV2-ISOL STMicroelectronics

ST-LINK/V2 Data brief ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 microcontrollers Features 5 V power supplied by a USB connector USB 2.0 full-speed compatible interface USB Type-A to Mini-B cable provided SWIM specific features: 1.65 V to 5.5 V application voltage support on the SWIM interface SWIM low-speed and high-speed modes support SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 ST-LINK/V2 (left) and ST-LINK/V2-ISOL (right). Pictures are not contractual. Horizontal connector reference: 214012 SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector JTAG/serial wire debug (SWD) specific features: 1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs JTAG cable for connection to a standard JTAG 20-pin 2.54 mm pitch connector JTAG support SWD and serial wire viewer (SWV) communication support Product status link Direct firmware update support (DFU) ST-LINK/V2 Status LED blinking during the communication with the PC Operating temperature from 0 C to 50 C 1000 V high isolation voltage (ST-LINK/V2-ISOL only) rms Description The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers. The single-wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 V . rms STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD-STM8) or ST Visual Programmer (STVP-STM8) software, or with integrated development environments from third-parties. STM32 applications use the USB full-speed interface to communicate with the STM32CubeIDE software tool or with integrated development environments from third-parties. DB1275 - Rev 6 - November 2020 www.st.com For further information contact your local STMicroelectronics sales office.ST-LINK/V2 Ordering information 1 Ordering information To order the ST-LINK/V2 in-circuit debugger and programmer, refer to Table 1. For a detailed description, refer to its user manual on the product web page. Table 1. List of available products Order code User manual ST-LINK description ST-LINK/V2 In-circuit debugger/programmer UM1075 In-circuit debugger/programmer with 1000 V digital isolation ST-LINK/V2-ISOL rms DB1275 - Rev 6 page 2/6