STSPIN32F0B STMicroelectronics

STSPIN32F0B Datasheet Advanced single shunt BLDC controller with embedded STM32 MCU Features Extended operating voltage from 6.7 to 45 V Three-phase gate drivers 600 mA sink/source Integrated bootstrap diodes Cross-conduction prevention 32-bit ARM Cortex -M0 core: Up to 48 MHz clock frequency 4-kByte SRAM with HW parity 32-kByte Flash memory with option bytes used for write/readout protection Bootloader FW available 3.3. V DC/DC buck converter regulator with overcurrent, short-circuit, and thermal protection 12 V LDO linear regulator with thermal protection 20 general-purpose I/O ports (GPIO) 5 general-purpose timers 12-bit ADC converter (up to 9 channels) 2 I C, USART and SPI interfaces One rail-to-rail operational amplifier for signal conditioning Comparator for overcurrent protection with programmable threshold Standby mode for low power consumption Product status link UVLO protection on each power supply: STSPIN32F0B V , V , V and V M DD REG BOOTx On-chip debug support via SWD Product summary Extended temperature range: -40 to +125 C Order Codes STSPIN32F0B Tray Applications STSPIN32F0BTR Tape and Reel Power tools Marking STSPIN32F0B FANs and pumps Package VFQFPN48 7x7x1mm Industrial automation Battery powered home appliances DS12907 - Rev 1 - February 2019 www.st.com For further information contact your local STMicroelectronics sales office.STSPIN32F0B Description 1 Description The STSPIN32F0B is a System-In-Package providing an integrated solution suitable for driving three-phase brushless motors using different driving modes. It embeds a triple half-bridge gate driver able to drive power MOSFETs with a current capability of 600 mA (sink and source). The high- and low-side switches of same half-bridge cannot be simultaneously driven high thanks to an integrated interlocking function. An internal DC/DC buck converter provides the 3.3 V voltage suitable to supply both the MCU and external components. An internal LDO linear regulator provides the supply voltage for gate drivers. The integrated operational amplifier is available for the signal conditioning, e.g. the current sensing across the shunt resistor. A comparator with a programmable threshold is integrated to perform the overcurrent protection. The integrated MCU (STM32F031C6 with extended temperature range, suffix 7 version) allows performing field- oriented control, the 6-step sensorless and other advanced driving algorithms. It has the write-protection and read-protection feature for the embedded Flash memory to protect against unwanted writing and/or reading. It is possible to download the firmware on-the-field through the serial interface thanks to the embedded bootloader. The STSPIN32F0B device also features overtemperature and undervoltage lockout protections and can be put in the standby mode to reduce the power consumption. The device provides 20 general-purpose I/O ports (GPIO) with the 5 V tolerant capability, one 12-bit analog-to-digital converter with up to 9 channels performing conversions in a single-shot or scan modes, 5 synchronizable general-purpose timers and supports an easy to use debugging serial interface (SWD). DS12907 - Rev 1 page 2/36