TS617IDT STMicroelectronics

TS617 Dual wideband high output current operational amplifier Features Wideband of 200 MHz/gain = 4 SO-14 Very high slew rate High output current -I-IN1N1 11 1414 OUOUTT11 Specified on 25 and 100- loads ++ Thermal shut-down set at Tj = 150 C +I+INN11 22 1313 NCNC Large protection on outputs 33 1212 A1A1 NCNC Power-down mode with high Z-out PoPowweer r VCC +VCC + 44 1111 VCC -VCC - Very low noise contcontrolrol Tested at 5 and 12-V supplies A0A0 55 1010 NCNC Single or dual supply operation +I+INN22 99 66 NCNC ++ Minimum and maximum limits are tested in full production -I-IN2N2 77 88 OUOUTT22 Applications Power line equipment Drivers for xDSL modems Video drivers Video distribution Description The TS617 is a wideband high output current dual operational amplifier optimized for driving high data rates on power lines and twisted pair telephone lines. The TS617 features a linearity on low resistive loads, large output swing and high output current, very low noise, low consumption and I-supply control and power-down mode with high Z-out and short settling times. November 2008 Rev 1 1/19 www.st.com 19 Obsolete Product(s) - Obsolete Product(s) Obsolete Product(s) - Obsolete Product(s) Absolute maximum ratings and operating conditions TS617 1 Absolute maximum ratings and operating conditions Table 1. Absolute maximum ratings Symbol Parameter Value Unit (1) V Supply voltage 14 V CC DC (2) V Differential input voltage 2 V id T Operating free air temperature range -40 to +85 C oper T Storage temperature -65 to +150 C stg T Maximum junction temperature 150 C j SO14 thermal resistance junction to ambient 103 C/W JA SO14 thermal resistance junction to case 31 C/W JC (3) SO14 maximum power dissipation (at Ta = 25 C) for P 1.2 W max T = 150 C j (4) HBM: human body model 2kV (5) ESD MM: machine model 200 V CDM: charged device model 1 kV 1. All voltage values are measured with respect to the ground pin. 2. Differential voltage is between the non-inverting input terminal and the inverting input terminal. 3. Short-circuits can cause excessive heating. Destructive dissipation can result from short circuits on amplifiers. An internal thermal shut-down set the circuit in power down mode automatically when the silicon temperature reaches 150C. 4. Human body model: 100 pF discharged through a 1.5 k resistor into P of device. min 5. This is a minimum value. Machine model ESD: a 200 pF capacitor is charged to the specified voltage, then discharged directly into the IC with no external series resistor. Table 2. Operating conditions Symbol Parameter Value Unit (1) V Power supply voltage 4.5 to13 V CC V Common mode input voltage 6 V icm 1. Tested in full production at 2.5 V and 6 V supply voltages. 2/19 Obsolete Product(s) - Obsolete Product(s) Obsolete Product(s) - Obsolete Product(s)