Product fact sheet Industrial TM CompactFlash Card C-440 Series up to UDMA6 / MDMA4 / PIO6 BU: Flash Products Date: February 06, 2014 Revision: 1.01 File: C-440 fact sheet CF-HxBU Rev101.doc Swissbit AG Swissbit reserves the right to change products or specifications without notice. Revision: 1.01 Industriestrasse 4 CH-9552 Bronschhofen www.swissbit.com C-440 fact sheet CF-HxBU Rev101 Switzerland industrial swissbit.com Page 1 of 3 C-440 Series Industrial UDMA CompactFlash Card, 2GByte up to 64GByte, 3.3/5V Supply Main Features Highly-integrated memory controller TM o CompactFlash specification 4.1, compatible with specification 5.0 o PCMCIA specification 2.1 & PC Card ATA Interface Specification 8, 7, 6, and 5 o True IDE mode compatible, up to UDMA6 / MDMA4 / PIO6 supported o Fix drive (IDE mode) & removable drive (PC card mode) as default in the same card o Hot swappable in PC card modes o Signal termination resistors to improve signal quality o LBA48 address support (LBA28 limitation on request) o Fix drive (IDE mode) & removable drive (PC card mode) as default configuration Small form factor o CFC Type I: 36.4mm x 42.8mm x 3.3mm Low-power CMOS technology 3.3V or 5.0V power supply, card drives bus with 3.3V, inputs 5V compatible Power saving mode (with automatic wake-up) S.M.A.R.T. support and extended vendor information Wear Leveling: equal wear leveling of static and dynamic data The wear leveling assures that dynamic data as well as static data is balanced evenly across the memory. With that the maximum write endurance of the device is guaranteed. Data Retention: 10 year (JESD47) Patented power-off reliability o No data loss of older sectors o Max. 32 sectors data loss (old data kept) High reliability o MTBF >3,000,000 hours 14 o Data reliability: < 1 non-recoverable error per 10 bits read o Number of connector insertions/removals: >10,000 o 24bit per double sector BCH ECC capability o Near Miss ECC handling at read (refresh and correct data, if multiple correctable errors detected) o Read Disturb Management (RDM, refresh and correct data after a certain number of read commands per block) High performance o Up to 133MB/s burst transfer rate in UDMA6 o Sustained Write performance: up to 40MB/s (UDMA6 untrimmed) o Sustained Read Performance: up to 65MB/s (UDMA6) o Trim command supported to increase random write performance o Up to 300 IOPS with Trim Support (4k random write) and up to 32 IOPS untrimmed Available densities o up to 64GBytes (SLC NAND Flash) Operating System support TM o Standard Software Drivers operation CompactFlash 2 Temperature ranges o Commercial Temperature range 0 +70C o Industrial Temperature range -40 +85C Life Cycle Management Controlled BOM RoHS compatible Swissbit AG Swissbit reserves the right to change products or specifications without notice. Revision: 1.01 Industriestrasse 4 CH-9552 Bronschhofen www.swissbit.com C-440 fact sheet CF-HxBU Rev101 Switzerland industrial swissbit.com Page 2 of 3