Z63000Z2910Z1Z61 TDK

Evaluation Kit CeraPlas HF Driver for CeraPlas series Series/Type: Evaluation Kit - CeraPLas HF Cold Plasma Source Ordering code: Z63000Z2910Z 1Z61 Date: 2018-09-04 Version: 7 Content of header bars 1 and 2 of data sheet will be automatically entered in headers and footers Please fill in the table and then change the color towhit. This ensures that the table disappears (invisible) for the customer PDF. Don t change formatting when entering or pasting text in the table and don t add any cell or line in and to it Identification/Classification 1 Evaluation Kit CeraPlas HF (header 1 + top left bar): Identification/Classification 2 Driver for CeraPlas series (header 2 + bottom left header bar): Ordering code: (top right header bar) Z63000Z2910Z 1Z61 Series/Type: (bottom right header bar) Evaluation Kit - CeraPLas HF Cold Plasma Source Preliminary data (optional): Preliminary data Department: PPD C R&D INT Date: 2018-09-04 Version: 7 EPCOS AG 2018. Reproduction, publication and dissemination of this publication, enclosures hereto and the information contained therein without EPCOS prior express consent is prohibited. EPCOS AG is a TDK Group Company. Evaluation Kit CeraPlas HF Z63000Z2910Z 1Z61 Driver for CeraPlas series Evaluation Kit - CeraPLas HF Cold Plasma Source Preliminary data Content of evaluation kit / CeraPlas HF cold plasma source Driver circuit for CeraPlas series CeraPlas HF with Package, with wires and two pins connector Copy of Datasheet for CeraPlas HF and the user guide for the driver circuit Specifications/Features 24 V single supply Approximately 4.5 W CeraPlas input power by default, selectable from approx. 2 to 7 W by software Driver supports CeraPlas HF Automatic frequency control with resolution in the range of mHz Phase control with resolution of at least 1 Introduction The CeraPlas driving circuit is intended to show the operating principle of CeraPlas. A unique control algorithm is used to drive the CeraPlas at its maximum efficiency under any conditions. The driving circuit can be operated by a set of jumper or alternatively via COM-Port commands using an RS232- adapter and an additional graphical user interface which is multi-platform software for adjusting CeraPlas to your specific application. Connection setup As shown in Fig.1 all possible interfaces are described. For running the CeraPlas the first time the following steps has to be done to accomplish a stable ignition of the plasma: 1. Plug in the CeraPlas to the green connector and tighten the screws to establish a good electrical connection 2. Plug in the green connector to the socket on the driving circuit 3. Connect a stabilized 24V +- 5% power supply with at least 500 mA current rating 4. Configure the Input power by shorten the user inputs 2-3 like in Tab. 2 5. Shorten User Input 1 by using a jumper to switch on the CeraPlas Since the voltage is applied the driver sends out different light pattern by using the build-in LED: Standby (CeraPlas is turned off): LED is blinking the amount of pulses correlates to the current operating mode. Active (CeraPlas is running): LED is blinking each 280 ms for 140 ms. Alternatively, the CeraPlas can also be controlled using the serial RS232-interface, see below for the connection and commands. PPD C R&D INT 2018-09-04 Please read Cautions and warnings and Page 2 of 8 Important notes at the end of this document.