15-Serie IA-A 09-Serie IA-A 31/10/14 08:13 Page85 IA series Low profile pushbutton switches for harsh environments - bushing 16 mm - momentary Distinctive features - Specifications - Overview UG1410A Resistant to frost, sand and hydrocarbons Tactile feedback Front panel sealed to IP65 and IP67 B1 ENVIRONMENTAL SPECIFICATIONS MATERIALS Front panel sealing (see drawing opposite) : IP65 and IP67 acc. to IEC 60529 Case/bushing : thermoplastic Salt spray : IEC 512-6, test 11f Actuator : polyurethane Operating temperature : -20C to +65C Contacts : silver, gold plated Multi-wire lead AWG20, 2 section 0,6 mm . ELECTRICAL AND GENERAL SPECIFICATIONS Terminal seal : epoxy Max. current/voltage rating with resistive load : 2A 24VDC Initial contact resistance : 100m max. PANEL MOUNTING Insulation resistance : 100 M min. at 500VDC Flat seal Dielectric strength : 500 Vrms Electrical life at full load : 1.000.000 cycles 1 Panel thickness : 7 mm (.276) max. Total travel : 1,5 mm (.059) +/- 0,3 mm Typical operating force : 7N +/- 2N Low level or mechanical life : 1.000.000 cycles Torque : 0,5 to 1Nm max. applied to nut IA SERIES Actuator Electrical Terminals Contacts Actuator colours Case colour shape functions F Flying leads 1 Silver, 1 Blue 00 Black R round 3 Normally gold plated 2 Black open (NO) 3 Green 5 NC/NO 4 Grey combined 5 Yellow 6 Red 7/1 White 9 Orange Dimensions : First dimensions are in mm while inches are shown as bracketed numbers. A sealing boot is available to protect the switches against frost and sand. See end of this catalogue. Mounting accessories : Standard hardware supplied : 1 hex nut 19 mm (.748) across flats and 1 flat seal. Knurled nut U3327 available on request. Packaging unit : 25 pieces The company reserves the right to change specifications without notice. APEM www.apem.com B1-8515-Serie IA-A 09-Serie IA-A 31/10/14 08:13 Page86 IA series Low profile pushbutton switches for harsh environments - bushing 16 mm - momentary Panel cut-out 16,2 mm (.657) Min. pitch for matrix mounting : - with standard hex nut : 27 x 27 mm (1.062 x 1.062) - with knurled nut U3327: 20 x 20 mm (.787x.787) CNC NO NO NC/NO combined MODEL STRUCTURE B1 NO model has 2 terminals only. 16.00x1.00SI Models (.629DIAx1.00IS) 15.00 (.590 DIA) Normally open (NO) IAR3F EPOXY C NC NO NC/NO combined 19.80 IAR5F (.779 DIA) Wire colours (NC/NO) : black = common, brown = NC, blue = NO CONTACT MATERIAL 1 Silver, gold plated ACTUATOR COLOURS 1 : blue - 2 : black - 3 : green - 4 : grey - 5 : yellow - 6 : red - 7/1 : white - 9 : orange CASE COLOUR 00 : black B1-86 www.apem.com APEM 1.20 10.00 (.393) (.047) 3.30 (.129) 18.50 maxi 500.0010 (19.685.393) (.728MAX.)