Automotive Relays
Plug-in Mini ISO Relays
Power Relay B
n
Pin assignment similar to ISO 7588 part 1
n
Plug-in terminals
n
Customized versions on request
24VDC versions with contact gap >0.8mm
Integrated components (e.g. resistor, diode)
Customized marking/color
Special covers (e.g. notches, release features, brackets)
Various contact arrangements and materials
Typical applications
Cross carline up to 35A for example: rear window defogger, battery
disconnection, power distribution (clamp 15)
F234_fcw1_bw
Contact Data 1 A 1 A 1 C 1 C Coil Data
Contact arrangement 1 form A, 1 form A, 1 form C, 1 form C, Rated coil voltage 12/24VDC
1 NO 1 NO 1 CO 1 CO
Rated voltage 12VDC 24VDC 12VDC 24VDC Coil versions, DC coil
Limiting continuous current Coil Rated Operate Release Coil Rated coil
5) 5)
form A/form B (NO/NC) code voltage voltage voltage resistance power
23C 50A 50A 50/35A 50/35A VDC VDC VDC 10% W
85C 35A 35A 35/25A 35/25A 001 12 8 1.5 85 1.7
125C 15A 15A 15/10A 15/10A 002 12 6.5 1 75 1.9
1)
Limiting making current 004 24 16 3 255 2.3
5) Without components in parallel.
A/B (NO/NC) 120A 120A 120/45A 120/45A
All figures are given for coil without pre-energization, at ambient temperature +23C.
Limiting breaking current,
A/B (NO/NC) 30A 20A 30/20A 20/10A
Limiting short-time current Insulation Data
2)
overload current, ISO 8820-3 1.35 x 35A, 1800s Initial dielectric strength
2.00 x 35A, 5s between open contacts 500V
rms
3.50 x 35A, 0.5s between contact and coil 500V
rms
6.00 x 35A, 0.1s between adjacent contacts 500V
rms
Jump start test, ISO 16750-1 24VDC for 5min, Load dump test
conducting nominal current at 23C ISO 7637-1 (12VDC), test pulse 5 V =+86.5VDC
s
Contact material Silver based ISO 7637-2 (24VDC), test pulse 5 V =+200VDC
s
3)
Min. recommended contact load 1A at 5VDC
Initial voltage drop, at 10A, typ./max.
form A (NO) 15/300mV 15/300mV 15/300mV 15/300mV Other Data
form B (NC) - - 20/300mV 20/300mV EU RoHS/ELV compliance compliant
6)
Frequency of operation, at nominal load 6 ops./min (0.1Hz) Protection to heat and fire according UL94 HB or better
4)
Operate/release time typ. 10/10ms Ambient temperature -40 to 125C
Electrical endurance, ops. Climatic cycling with condensation,
5 5 5 5
resistive load, A (NO) >2.5x10 >2.5x10 >2.5x10 >2.5x10 EN ISO 6988 6 cycles, storage 8/16h
30A, 20A, 30A, 20A, Temperature cycling,
14VDC 28VDC 14VDC 28VDC IEC 60068-2-14, Nb 10 cycles, -40/+85C (5C/min)
5 5
resistive load, B (NC) - - >1x10 >2.5x10 Damp heat cyclic,
20A, 10A, IEC 60068-2-30, Db, Variant 1 6 cycles, upper air temp. 55C
14VDC 28VDC Damp heat constant, IEC 60068-2-3, Ca 56 days
6
Mechanical endurance typ. 1x10 ops. Category of environmental protection,
1) The values apply to a resistive or inductive load with suitable spark suppression and
IEC 61810 RT I dustproof
at maximum 14VDC for 12VDC or 28VDC for 24VDC load voltages. For a load current
Degree of protection, IEC 60529 IP54
duration of maximum 3s for a make/break ratio of 1:10.
Corrosive gas
2) Current and time are compatible with circuit protection by a typical automotive fuse.
3 3
IEC 60068-2-42 102cm /m SO , 10 days
2
Relay will make, carry and break the specified current.
3 3
IEC 60068-2-43 10.3cm /m H S, 10 days
2
3) See chapter Diagnostics of Relays in our Application Notes or consult the internet at
Vibration resistance (functional)
Automotive Relays
Plug-in Mini ISO Relays
Power Relay B (Continued)
Other Data (continued) Accessories
Terminal type plug-in, QC For details see datasheet Connectors for Mini ISO Relays
Cover retention
axial force 150N
pull force 200N
push force 200N
8)
Terminal retention
pull force 100N
push force 100N
resistance to bending 10N
force applied to side 10N
torque 0.3Nm
Weight approx. 35g (1.2oz)
Packaging unit 200 pcs.
6) Refers to used mateials.
7) No change in the switching state >10s. Valid for NC contacts, NO contact values
significantly higher.
8) Values apply 2mm from the end of the terminal. When the force is removed, the terminal
must not have moved by more than 0.3mm.
Terminal Assignment
NO NOR NO_2x87 NOR_2x87
1 form A, NO 1 form A, NO with resistor 1 form A, 1 NO (2x87) 1 form A, 1 NO (2x87) with resistor
85 87 87 85 87 87
85 87 85 87
86 30 86 30
86 30 86 30
NOD_2x87 CO COR COD
1 form A, 1 NO (2x87) with diode 1 form C, CO 1 form C, CO with resistor 1 form C, CO with diode
85 87 87a 85 87 87a 85 87 87a
85 87 87
86 30 86 30 86 30
86 30
2
03-2014, Rev. 0314 Datasheets and product specification ac- Datasheets and product data is subject to the Datasheets, product data, Definitions sec-
www.te.com cording to IEC 61810-1 and to be used only terms of the disclaimer and all chapters of tion, application notes and all specifications
2014 Tyco Electronics Corporation, together with the Definitions section. the Definitions section, available at are subject to change.
a TE Connectivity Ltd. company.