1618105-2 TE Connectivity

1 4 /8 5 3 /8 1 4 /2 Ground Fault Relays WILMAR Protective Relays WGD Series Floating Ground Function: ANSI/IEEE C37.90-1978 UL file No. E58048 CSA file No. LR61158 WILMAR Ground Fault Detectors are used to sense leak- age current to ground in power transformers and gen- erators. They are available for both AC and DC systems. TERMINAL STRIPS Some generator systems provide auxiliary power out- 6 - 32 SCREWS lets for small equipment. WILMAR GFDs eliminate per- sonnel risk of accessing these outlets if a ground fault exists. Diesel locomotives and railroad line signal boxes also use WILMAR GFDs for operational control purposes. The GFD monitors both positive and negative grounds for fault currents and can trigger either notification or system shutdown if these are detected. WILMAR GFDs are available for both grounded and ungrounded sys- tems. Operation: When the resistance between any phase to ground falls below the set point the relay will energize The normally closed contacts will open, the normally open contacts will close. 11 /64 DIA. 4 MTG. HOLES Note: Dimensions in inches. Multiply values by 25.4 for dimensions in mm. PART NUMBER SELECTION Sample Part No. WGD- Type: Volts L-L Trip Point Adj. Phase to Ground 115-120AC 115 11-55K 120-120AC 120 12-60K 200-120AC 200 20-100K 208-120AC 208 21-105K PRODUCT SPECIFICATIONS 220-120AC 220 22-110K Part Number WGD Series 230-120AC 230 23-115K Sensing Voltage (10%) ................. 3 phase, 3-wire. See table 240-120AC 240 23-115K 380-120AC 380 38-190K Control Voltage ................................ 120 Volts AC 400-120AC 400 40-200K Contacts Trip Points (sensitivity) .... Screwdriver adjustable. See Table. 416-120AC 416 42-210K 440-120AC 440 44-220K Pick-up Time Delay.......................... 1.5 seconds approximately 460-120AC 460 46-230K Contact Ratings ................................ 5 amp resistive at 120 VAC or 28 VDC 480-120AC 480 48-240K o o Operating Temperature .................... -40 C to +65 C 525-120AC 525 52-260K 575-120AC 575 57-285K Temperature Effects ......................... 1% over temperature range 600-120AC 600 60-300K Power Consumption ........................ Sensing: 2 mA/Phase Approx., Control: 2VA at 120VAC Notes: Surge Withstand Capability ............. In accordance with the requirements of ANSI/IEEE 1. Remove screw for access to the pick-up adjustment potentiometer. 2. Clockwise rotation of the adjustment potentiometer will raise the relay sensitivity. 44 Tyco Electronics / www.tycoelectronics.com / Factory Direct Technical Support: 800-253-4560, ext. 2023 (U.S., Canada, Mexico) or 805-220-2020, ext. 2023 (International) 3.0 1 4 /4 1 3 /2