Jan 2017 REV B PRO-CRIMPER Hand Tool grade tool and is designed The PRO-CRIMPER Hand Tool is a Commercial grade toold and is designed institutional applications. te application speci cation, of Figure 1 Reason for revision is provided in Section 9, REVISION SUMMARY. PROCRIMPER III Hand Tool Assembly 2249281 consists of Die Assembly 2249282 and PROCRIMPER III Hand Tool Frame 3549401. The The tool features a tool frame with a stationary jaw die assembly consists of two crimping dies. Read and handle, a moving jaw, a moving handle, and an these instructions thoroughly before crimping any adjustable ratchet that ensures external strain relief connectors. crimping. The tool frame holds a die assembly with a seating chamber and two crimping chambers. The die assembly features an indenter die and an anvil die. Die retaining pins and die retaining screws are used to position and secure the dies in the tool frame. To obtain information on CommScope products, 2017 CommScope, Inc. This product is covered by one or more U.S. All Rights Reserved contact your local CommScope account patents or their foreign equivalents. For patents, see www.commscope.com/ProductPatent/ProductPatent.aspx representative, PartnerPRO Network Partner or visit our website at www.commscope.comFigure 2 and indenter in place, then tighten both die retaining screws. 9. To disassemble, close the tool handles until the 1. Open the tool handles and remove the two die ratchet releases, remove the two die retaining retaining screws from the tool jaws. screws, and the four die retaining pins, and slide the anvil and indenter out of the tool jaws. 2. Place the anvil die so that the chamfered side faces outward when mounted in the moving jaw of the tool frame. Assemble the modular plug connector according to 3. Insert the two die retaining pins. Application Specification 1146016. Insert the 4. Insert the die retaining screw through the jaw external strain relief into the modular plug as shown in and through the anvil die, and tighten the screw Figure 3, Detail A, and proceed as follows: just enough to hold the die in place. Do not tighten 1. Squeeze tool handles together and allow them the screw completely at this time. to open fully. 5. Observe the wire insulation diameter markings 2. Position the modular plug assembly in the on the indenter die. Place the indenter die so that seating chamber on the anvil die as shown in the crimping chamber to be used is facing outward Figure 3, Detail B. Make sure that the external when mounted in the stationary jaw of the tool strain relief faces the indenter die and that the frame. support barrel does not enter the seating chamber. 6. Insert the two die retaining pins. 3. Hold the modular plug assembly in position and squeeze the tool handles together until ratchet 7. Insert the die retaining screw through the jaw releases. Allow tool handles to open and remove and the indenter die, and tighten the screw just the modular jack assembly. enough to hold the die in place. Do not tighten the 4. Position the modular plug assembly in the screw completely at this time. crimping chamber on the anvil die so that the 8. Carefully close the tool handles, making sure opening in the external strain relief support barrel that the anvil and indenter align properly. Continue faces the indenter die. Make sure the back of the closing the tool handles until the ratchet in the tool modular plug butts against the edge of the die. See frame has engaged sufficiently to hold the anvil Figure 3, Detail C. B