108-115089 Product Specification 11FEB2015 REV.A Normal entry anti-buckling Block SIM Connector 1. SCOPE 1.1. Content This specification covers performance, tests and quality requirements for Anti-buckling Block SIM connector. Applicable product descriptions and part numbers are as shown in product drawing. 1.2. Qualification When tests are performed on the subject product line, procedures specified shall be used. All inspections shall be performed using the applicable inspection plan and product drawing. 2. APPLICABLE DOCUMENTS The following documents form a part of this specification to the extent specified herein. Unless otherwise specified, the latest edition of the document applies. In the event of conflict between the requirements of this specification and the product drawing, the product drawing shall take precedence. In the event of conflict between the requirements of this specification and the referenced documents, this specification shall take precedence. TE Connectivity Documents: 109-197: Test Specification (AMP Test Specifications vs. EIA and IEC Test Methods) 501-115100: Test Report. 3. REQUIREMENTS 3.1. Design and Construction Product shall be of the design, construction and physical dimensions specified on the applicable product drawing. 3.2. Materials Materials used in the construction of this product shall be as specified on the applicable product drawing. 3.3. Ratings A. Voltage: 10 V DC Max. B. Current: 0.2 A Max. C. Operating Temperature: -40 to 85 D. Storage Environment: Temperature: - 5 to 40 Relative humidity: 15%-70% 1 of 6 Rev A 108-115089 Product Specification 11FEB2015 REV.A 3.4. Performance and Test Description Product is designed to meet the electrical, mechanical and environmental performance requirements. Unless otherwise specified, all tests shall be performed in the room temperature(5 35), relative humidity(45 85), air pressure(86106kPa), and special case temperature(18 22), relative humidity(6070), unless otherwise specified. 3.5. Test Requirements and Procedures Summary Test Description Requirement Procedure Visual, dimensional and functional per Examination of the Meets requirements of product applicable inspection plan. In accordance with product drawing. IEC 60512-1-1and IEC 60512-1-2. ELECTRICAL IEC 60512-2-1 Measure at nominal working position (20 mV, (Low Level) 100 mA max.) Simple sketch showing the Initial, 100m Max. Contact Resistance testing method have to be added in test report After test, 150m Max. (LLCR). template. Four-wire measurement method must be used. See Figure 1. IEC 60512-3-1 Unmated connector with 100 V DC between Insulation resistance. 100 M Min. adjacent contact for 1 min. IEC 60512-4-1. Unmated connector with 200 V AC between Dielectric strength No breakdown adjacent contact for 1 min. Temperature Rise After test, 30C Max. EIA-364-70A Connect series, Mate connector and measure the temperature rise at the rated current after 2hours. MECHANICAL Normal force test equipment Contact normal force 0.2~0.9 N EIA-364-28E No physical damage. See para. 3.7.2. Figure 2. No change to performance. Apply for 2 hours in each 3 mutually No discontinuity greater than 1.0 perpendicular axes(total 6 hours). Vibration microsecond. Frequency=10-55-10Hz (Sweep time :1 minute max.) Amplitude=1.5mm, Current=100mA EIA-364-27B See para. 3.7.2. Figure 2. Apply 3 successive shocks in each direction No physical damage. along the 3 mutually perpendicular axes(total 18 No change to performance. Physical shock shocks) No discontinuity greater than 1.0 microsecond. Pulse shape=half sine Peak acceleration=490m/s2(50G) Duration of pulse=11ms 2 of 6 Rev A