59:8;*:065$/,,:
$+# .**)+- + !%#- #* $+ $-,
& #,<
#0./: (5+ of the wire support bracket aligns with the flat edge
63+05.
$;7768: 8(*2,: at the back of the crimper. See Figure 2.
$*8,=:?
3. Using the hex wrench, thread (but do not
,-: (5+
tighten) two of the holding screws with lock
$;7768: 8(*2,:
washers into the elongated holes of the crimper.
6
$! # !
6*2(9/,8
% % # # # $ !# ! #
:?
! %
% # # ! # $ !# ! #
63+05.
$*8,=:?
4. Hold the wire support bracket so that it fits
tightly against the crimper, then push the wire
support bracket toward the flat edge at the back of
6
the crimper as far as possible (the elongated holes
6*2(9/,8
will allow this).
:?
5. Tighten the holding screws enough to flatten the
,>8,5*/
lock washers. DO NOT overtighten the holding
screws; otherwise, the screws could bottom and
shear off into the crimper.
#& #&
%
08,$;7768:
$ !# ! #
8(*2,: %()
$:(5+(8+
3;,
050
3(*2
Figure 1
365.(:,+
63,
Wire Support Bracket Repair Kits 2291881 and 2
!3(*,9
are used to replace the wire support brackets of the
hand tools listed in Figure 1.
63+05.$*8,=
!3(*,9
Reasons for reissue of this instruction sheet are
(*/ 8(*2,:
8047,8
provided in Section 4, REVISION SUMMARY.
08,$;7768:
8(*2,:
Figure 2
The repair kit contains the components shown in
Figure 1. The kit includes an extra set of screws and
6. Repeat Steps 2 through 5 for the remaining wire
lock washers.
support bracket.
7. After replacing the wire support brackets, crimp
five halftap and five through splices; then inspect
them according to the instruction sheet included
1. Remove the wire support brackets from the tool
with the tool.
by removing the four holding screws and lock
washers. Discard these parts.
# # & # #
2. Fit one of the wire support brackets against the ! $ ! # ## ## #
crimper so that the protruding tab rests on the top# # !# # % !$ !#
of the crimper. Make sure the flat edge at the front !
% $$ $% % # %/09*65:8633,++6*;4,5:099;)1,*::6*/(5.,
%?*6 3,*:8650*9 68768(:065 (8809);8. !
6-
33 5:,85(:065(3#0./:9#,9,8<,+ !# & % # % 683(:,9:8,<09065(5+#,.065(3 ;9:64,8$,8<0*,
% 36.6(5+%?*6 3,*:8650*9(8,:8(+,4(829 <090:6;8=,)90:,(:/// -0!)#&#!-+)($!, !)
%8(+,4(82 :/,8786+;*:9 36.69 (5+*647(5?5(4,9;9,+(8,:/,7867,8:?6-:/,088,97,*:0<,6=5,89
Revisions to this instruction sheet include:
Updated document to corporate requirements
Added text to Section 2
Added Kit 2
Replaced Paragraphs 3.1 and 3.2 with
reference to tool instruction sheet