2323859-1 TE Connectivity

Application Specification LUMAWISE Drive Type Z50 LED Holder 114-133082 7 SEPTEMBER REV 18 NOTE All numerical values are in metric units with U.S. customary units in brackets . Dimensions are in millimeters. Unless otherwise specified, dimensions have a tolerance of 0.10 and angles have a tolerance of 2. Figures and illustrations are for identification only and are not drawn to scale. 1. INTRODUCTION This application guideline covers the requirements for application of the LUMAWISE Drive Type Z50 LED Holder (hereafter referred to as LUMAWISE Drive). The LUMAWISE Drive allows direct attachment of the LED to a cooling device using two customer-supplied M3 or No. 4-40 with minimum length of 12mm mounting screws and has a 4 position CT connector (292228-4) to power and regulate the onboard driver. The LUMAWISE Drive features a COB opening, 292228-4 Mini CT Connector and two screw holes that each accept a screw for mounting. The COB opening accepts the COB, and a visible LED minus (-) & plus (+) polarity indicator on the bottom of the LUMAWISE Drive indicates orientation of the COB. When corresponding with personnel, use the terminology provided in this specification to facilitate inquiries for information. Basic terms and features of this product are provided in Figure 1. Example of the LUMAWISE Drive Type Z50 Top View Bottom View Screw Hole COB Plus (+) Contacts (2 Places) Polarity Indicator COB Minus (-) Polarity Indicator COB LES Opening Opening Mini CT connector entrance Mini CT connector entrance Figure 1 2. REFERENCE MATERIAL 2.1. Customer Assistance Reference Product Base Part Number x-2213699-y (on/off version) and x-2316510-y (0-10V version) are representative of the LUMAWISE Drive Type Z50 platform. Use of these numbers will identify the product line and help you to obtain product and tooling information. Such information can be obtained through a local Representative, by visiting our website at www.te.com, or by calling PRODUCT INFORMATION or the TOOLING ASSISTANCE CENTER at the numbers at the bottom of this page. 2017 TE Connectivity Ltd. family of companies. PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. 1 of 10 All Rights Reserved. For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners. 114-133082 2.2. Specifications Product Specification 108-133082 provides product performance and test information. 2.3. Instructional Material Instruction Sheets (408-series) provide product assembly instructions. 2.4. Datasheet Datasheet 1-1773935-6 provides general information about the product. 3. REQUIREMENTS 3.1. Safety Do not stack product shipping containers so high that the containers buckle or deform. It is recommended using the LUMAWISE Drive (in combination with the COB) with low-voltage low energy circuits supplied from a class 2 or low-voltage limited energy (LVLE) power source, for EU Class I or II. Input and output of the power supply should be isolated from each other. 3.2. Storage The LUMAWISE Drive should remain in the shipping containers until ready for use to prevent deformation to the contacts. The LED holders must be stored in a temperature range of -20 to 60C -4 to 140F and used within 1 year from the date code located on the bottom of the holder. The LUMAWISE Drive should be used on a first in, first out basis to avoid storage contamination that could adversely affect performance. 3.3. Functional overview Figure 2 show an overview of the functional blocks of the LUMAWISE Drive per version. Figure 2 2 of 10 18