3521750KFT TE Connectivity

SMD POWER RESISTORS AEC-Q200 QUALIFIED Type 3521 Series Key Features 2 Watts at 70C Small size to power ratio Supplied on tape Value marked on resistor 500 volt maximum overload 250 volt maximum TE Connectivity is pleased to announce that our 3521 series high power Thick Film working Chip Resistor is now AEC-Q200 Qualified. This low cost device, suitable for auto voltage placement in volume, and for most applications, including high frequency operations, owing to the short lead structure, is attractively priced and available on Terminal finish 7 reels of 4000 pieces. matte Sn over Ni Characteristics Electrical AEC-Q200 Power Rating 2W Qualified Resistance Range 0.1 ~ 10M Tolerance 1% 5% Max. Working Voltage 250V Max. Overload Voltage 500V Dielectric Withstanding Voltage 500V Temperature Range -55C +155C Ambient Temperature 70C Resistors shall have a power rating based on continuous load operation at an ambient temperature of 70 . For temperature in excess of 70 , The load shall be derated as shown below: Dimensions in Dimensions Shown for 9-1773463-5 Rev G 02/2020 For Email, phone or live chat, millimetres unless reference purposes only. go to: www.te.com/help otherwise specified Specifications subject to change SMD POWER RESISTORS AEC-Q200 QUALIFIED Voltage Rating: Resistors shall have a rated direct-current (DC) continuous working voltage or an approximate sine-wave root-mean-square (RMS) alternating-current (AC) continuous working voltage at commercial line frequency and waveform corresponding to the power rating , as determined from the following formula: RCWV = P x R Where: RCWV = Rated DC or RMS AC continuous working voltage at commercial-line frequency and waveform (volt) P = Power Rating (watt) R = Nominal Resistance (ohm) In no case shall the rated DC or RMS AC continuous working voltage be greater than the applicable maximum value. Construction & Dimensions: Dimensions: (mm) L W H 6.350.10 3.200.20 0.550.10 0.600.25 0.500.20 Dimensions in Dimensions Shown for 9-1773463-5 Rev G 02/2020 For Email, phone or live chat, millimetres unless reference purposes only. go to: www.te.com/help otherwise specified Specifications subject to change