CII Low Signal Relays CII Low Signal Relays Double Pole, Magnetic Latching, 2 Amps and Less (Continued) Electrical Characteristics Operating Characteristics Magnetic Latching, Contact Ratings Operate Time 4 ms Grid-space, Relays DC resistive 2 amps at 28 volts Release Time 4 ms Type 3SAM (2PDT) 1 DC inductive 0.5 amps at 28 volts, Contact Bounce 2 ms 200 mH Dielectric Strength AC resistive 1 amp at 115 volts 1,000 volts rms at sea level (single coil), case not grounded Product Facts 700 volts rms across contact gap AC resistive 0.25 amps at 115 volts n Special shock designs up to Insulation Resistance (dual coil), case not grounded 700 G, 1 ms 1,000 megohm min. Low-level 50 A at 50 mV Peak AC or DC n Suitable for pulse operation Environmental Characteristics Contact Resistance Vibration 30 G, to 3,000 Hz n No hang up feature on low 0.050 ohms initial Shock 150 G at 11 ms power pulses 0.100 ohms after life test This relay has memory in Temperature -65C to +125C Life n Qualified to MIL-R-39016/32 that the contact positions do 100,000 operations at rated load See page 1-52 for Mounting Forms, not change when coil power n Special wiring is available 1,000,000 at low-level Terminals and Circuit Diagrams. is removed. Switching is accomplished by applying power to the applicable coil (dual coil) or with the appli- cable polarity (single coil). The low switching power requirements are further enhanced by its ability to operate from capacitor dis- charge or other pulses or through its own contacts for batteries or similarly limited supplies. Applicable over the operating temperature range in circulating air. Applicable over the operating temperature range in circulating air. Initial or inspection value. Allow 20% increase in value of maximum pickup Initial or inspection value. Allow 20% increase in value of maximum pickup during rated life. during rated life. of these relay characteristics, the Ordering Instructions catalog number is identified as Example: The relay selected in this 3SAM6014N2. The letter R following example is a 2PDT magnetic latch- sensitivity code indicates relay ing relay, current calibrated, four- received 5000 operation miss-test. hole end bracket mounting, solder Ex. 3SAM6014N2R. hook header, 1500 ohms coil resist- ance, and 75 mW sensitivity. By choosing the proper code for each * The part number example shown on this page is for catalog items. For a list of specific QPL part numbers, please see the index in Section 15. 1-51 Catalog 5-1773450-5 Dimensions are shown for Dimensions are in millimeters USA: +1 800 522 6752 For additional support numbers Revised 3-13 reference purposes only. unless otherwise specified. Asia Pacific: +86 0 400 820 6015 please visit www.te.com Specifications subject UK: +44 800 267 666 www.te.com to change.CII Low Signal Relays Double Pole, Magnetic Latching, 2 Amps and Less (Continued) Mounting Forms (3SAM) (Vibration note with each form is acceleration from 55 to 3000 Hz) Header and Connection Diagrams Header Types 1-52 Catalog 5-1773450-5 Dimensions are shown for Dimensions are in millimeters USA: +1 800 522 6752 For additional support numbers Revised 3-13 reference purposes only. unless otherwise specified. Asia Pacific: +86 0 400 820 6015 please visit www.te.com Specifications subject UK: +44 800 267 666 www.te.com to change.