44B9514 SPECIFICATION CONTROL DRAWING Date Revision TITLE ONE CONDUCTOR CABLE, DOUBLE SHIELDED, JACKETED, GENERAL PURPOSE, 600 VOLT 5-24-07 B This specification sheet forms a part of the latest issue of Raychem Specification 55A. JACKET - RADIATION-CROSSLINKED, SHIELDS - TIN-COATED COPPER COMPONENT WIRE - 44A0111 MODIFIED ETFE CABLE CONSTRUCTION DETAILS INNER OUTER JACKET THICKNESS OUTSIDE DIAMETER CONDUCTOR MAXIMUM PART NUMBER SHIELD SHIELD (in.) (in.) SIZE WEIGHT 1/ SIZE SIZE (AWG) (lbs/1000 ft.) MINIMUM MAXIMUM NOMINAL MAXIMUM (AWG) (AWG) 44B9514-22-* 22 38 38 .005 .010 .097 .102 11.5 44B9514-20-* 20 38 38 .005 .010 .105 .110 14.0 CABLE RATINGS AND ADDITIONAL REQUIREMENTS LOW TEMPERATURE-COLD BEND: -55 5C for 4 hours TEMPERATURE RATING: 150C Maximum continuous conductor temperature SHIELD COVERAGE: 85% (minimum) (each) VOLTAGE WITHSTAND TEST (Post Environmental): VOLTAGE RATING: 600 volts (rms) at sea level 1000 volts (rms), 60 Hz, 1 minute BLOCKING: 200 3C for 6 hours CROSSLINK VERIFICATION: 300 5C for 6 hours PART NUMBER: DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz, Conductor to shield The * in the part numbers above shall be replaced by color code designators with a dash separating the component wire color from the FLAMMABILITY: Procedure 1, 3 seconds (maximum) jacket color. 3 in. (maximum) no flaming of facial tissue JACKET COLOR: White preferred 1/ Example:AWG 20, white component wire white jacket JACKET ELONGATION AND TENSILE STRENGTH: Elongation, 50% (minimum) 44B9514-20-9-9 Tensile Strength, 5000 lbf/in (minimum) JACKET FLAWS: Spark Test, 1500 volts (rms) Impulse Dielectric Test, 6.0 kV (peak) NOTE: Nominal values are for information only. Nominal values are not requirements. This cable shall meet all constructional requirements of M27500 (AWGML1V23) Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: 901/902... MAY BE REPLACED BY Axxx.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. RAYCHEM is a trademark of Tyco Electronics Corporation. Raychem Wire & Cable 501 Oakside Avenue DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL Redwood City, CA 94063-3800 Page 1 of 1 Phone: 1-800-227-8816 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. Fax: 1-650-361-6297 REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. 2007 Tyco Electronics Corporation. All rights reserved.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Hook-up Wire category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : 002333-000 M81044/12-22-6 M81044/9-8-9 743094-001 81044/12-18-9CS3209 8538-009-1000 ATFC0311-20-5D EF5675-000 BFWUL3239-24-PINK 22759/34-16-9CS2621 22759/42-24-9CS2620 933205-000 284711-000 961473-000 30802-009-250 30808-010-500 30810-010-500 99M0111-20-2 A00594-000 190571-000 22759/41-12-9CS2620 22759/41-16-9CS2620 22759/43-10-9CS2873 265925-000 CM9524-000 CMC-0553-1-9 31510-010-250 31514-009-500 32412-009-500 34401-010-250 34402-010-500 M81044/9-4-9 391441-BK007 400R0111-10-9 431660-000 ATFC0311-20-0 ATFC0311-20-3 44/7024-26-9-9 44A0112-22-9CS3184 456157-000 BFW-UL3239-24- WHITE 55/0312-26-6L-CS2570 55A0811-12-9 55A6087-20-9-9-9 55A6315-22-9-9CS2632 55A7400-22-9/96-9CS2275 55A9002-30-5 55PC0211-20-5CS2502 55PC0811-6-9CS2637 55PC1211-22-9-9CS3278