473283-001 TE Connectivity

Specification Control 44B9202 Drawing 3 conductor cable Issue D - 4/6/2009 Identification, colors & marks Cross section B 3/6 C C A 9-9 Components ID Quantity Part number Description A 1 44A1811-22 Primary wire, round shielded, jacketed B 1 44A0821-20 Twisted pair C 2 FIL-11-0.075 Cross-linked ETFE Filler 0.075 OD Cable Outer Description Thickness OD Inches mm Inches mm Core 0.241 6.12 Shield Round tinned copper 38 awg regular 0.009 0.22 0.258 6.55 Jacket Thermorad HT white 0.009 0.22 0.275 6.98 Cable OD tolerance + 0.014 + 0.36 Raychem SPEC 55A Specification 42.74 lb/kft 63.72 Kg/Km Weight Page 1 of 2 This specification sheet takes precedence over documents referenced herein. Referenced documents shall be of the issue in effect on date of invitation to bid. Proposed specification control drawings may be altered prior to final issue. RCD Version 1.2 Level 1 Ser 5 RWC 8/7/95Specification Control 44B9202 Drawing 3 conductor cable Issue D - 4/6/2009 Continued Physical properties Jacket tensile strength 5000 psi minimum Jacket elongation 50% minimum Jacket Wall .007 inch minimum Shield Coverage 85% minimum Environmental properties Accelerated Aging 300 3C for 7 hours Voltage Withstand (Post Environmental) 1000 volts (rms), 60 Hz. 1 minute Electrical properties Voltage withstand (dielectric) 1500 volts (rms) conductor to conductor and shield 500 volts (rms) shield to shield when applicable per WC 27500. Coax Components to their own SCD Jacket Flaws Spark Test: 3 kV (rms) Impulse Dielectric Test: 6.0 kV (peak) Notes Colors Color code designators shall be in accordance with MIL-STD-681. Dimensions Dimensions are in inches, and unless otherwise designated, are nominal. The following is the key to the descriptions in the left hand view of the cable on Identification, Colors & Marks Page 1. Line 1: Identifies the component per the components ID list. Line 2: Color codes. Line 3: Mark on component mark on component jacket. Minimum length Cable will be supplied in 50 ft. minimum lengths unless otherwise specified Export License Note The information contained on this drawing may be subject to International Traffic in Arms Regulations (ITAR) or Export Administration Regulations (EAR) controls and may not be disclosed to any foreign person or firm, including foreign persons employed by or associated with your firm, without first complying with all requirements for obtaining an export license if applicable. Part Number Note Other codes and suffixes may be added to the Part Number as necessary, to capture any additional requirements imposed by the purchase order Specification Information This drawing is the property of Tyco Electronics Corporation and may not be used for any purpose other than for that which it is supplied without the express written authority of Tyco Electronics Corporation. Trademarks The TE logo, Tyco Electronics, Raychem, SPEC 55A and Thermorad are trademarks. Page 2 of 2 This specification sheet takes precedence over documents referenced herein. Referenced documents shall be of the issue in effect on date of invitation to bid. Proposed specification control drawings may be altered prior to final issue. RCD Version 1.2 Level 1 Ser 5 RWC 8/7/95