RW-2500-2 Revision 3 Page 1 of 11 November 2015 Specification RW-2500-2 Document Number: 108-121005 TMS Heat Shrinkable Identification Sleeves SCOPE This quality assurance specification sheet, when used with RW-2500, establishes the product characteristics. The operating temperature for this product is -55C to +135C. The IBM daisy wheel printer and ink cartridge developed for TMS is now obsolete. TE can only guarantee the performance properties covered in this standard, and not any marking applied using non-recommended printing systems. Where non-standard printing systems are used, customers are required to carry out their own validation testing. Products are available in 2:1 shrink ratio (refer to Table 1 for more details). Laser markable using industrial standard YAG lasers. The tube size for qualification testing is inch (6.4mm) as supplied internal diameter. Approved Signatories: This document is electronically reviewed and approved by TE Connectivity. TE CONNECTIVITY, SWINDON, UK While TE Connectivity has made every reasonable effort to ensure the accuracy of the information in this specification, TE Connectivity does not guarantee that it is error- free, nor does TE Connectivity make any other representation, warranty or guarantee that the information is accurate, correct, reliable or current. TE Connectivity reserves the right to make any adjustments to the information contained herein at any time without notice. TE Connectivity expressly disclaims all implied warranties regarding the information contained herein, including, but not limited to, any implied warranties of merchantability or fitness for a particular purpose. The dimensions in this document are for reference purposes only and are subject to change without notice. Specifications are subject to change without notice. Consult TE Connectivity for the latest dimensions and design specifications. If this document is printed it becomes uncontrolled. RW-2500-2 Revision 3 Page 2 of 11 November 2015 1. REQUIREMENTS 1.1 Composition and Appearance The product shall be fabricated from irradiated, thermally stabilized modified polyolefin compound. It shall be homogeneous and essentially free from flaws, defects, pinholes, bubbles, seams, cracks or inclusions. 1.2 Dimensions The product shall be supplied as cut sleeves mounted on bandoliers/carrier as shown in figure 1 and to the dimensions shown in table 1 or 2. 2. PRODUCT DRAWING 2.1 TMS as supplied Note: Dimensions in inches (mm) 2.5 (63) nom 0.5 (12.7) nom. 0.544 (13.8) nom. SLEEVE LENGTH Figure 1. TMS format TE CONNECTIVITY, SWINDON, UK While TE Connectivity has made every reasonable effort to ensure the accuracy of the information in this specification, TE Connectivity does not guarantee that it is error- free, nor does TE Connectivity make any other representation, warranty or guarantee that the information is accurate, correct, reliable or current. TE Connectivity reserves the right to make any adjustments to the information contained herein at any time without notice. TE Connectivity expressly disclaims all implied warranties regarding the information contained herein, including, but not limited to, any implied warranties of merchantability or fitness for a particular purpose. The dimensions in this document are for reference purposes only and are subject to change without notice. Specifications are subject to change without notice. Consult TE Connectivity for the latest dimensions and design specifications. If this document is printed it becomes uncontrolled.