599866-000 TE Connectivity

shrinkHOoP Cable Clamp Heat Shrink Grommet Sizes 1 and 5 c b a L Table of Dimensions, inch (mm): Outside Overall Inside Diameter Part Diameter Length Descriptio Max. Recd Recovered Recovered Min. Exp. (a) n (b) (c), Ref L, Ref URHR-1 1.00 (25) 0.08 (2.0) 0.250 (6.3) 0.50 (13) URHR-5 2.00 (51) 0.20 (5.1) 0.812 (20.5) 0.75 (19) Material: heat shrinkable, crosslinked polyolefin, meets MIL-I-81765/1 Type II with Shore Hardness value 35+/- 5. Color: Black shrinkHOoP is a Trademark of Tyco Electronics Specification Control Drawing Tyco Electronics Corporation Title: 300 Constitution Drive shrinkHOoP Cable Clamp Heat Menlo Park, CA 94025 USA Shrink Grommet Tyco Electronics reserves the right to amend this drawing at any time. Document No. Users should evaluate the suitability of the product for their application. URHR-1-and-5 UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. Rev.: Rev. Date: METRIC DIMENSIONS ARE SHOWN IN BRACKETS F December 9, 2004 DRAWN BY: CAGE CODE: Org. Date: File name: SCALE: SIZE: SHEET: U.NGUYEN 06090 10/03/2001 R040892 None A 1 of 2 2004 Tyco Electronics Corporation. All rights reserved If this document is printed it becomes uncontrolled. Check for the latest revision. Table 2: Properties Property Requirements Test method Tensile strength 1200 psi (8.3 Mpa) minimum ASTM D-412 Physical Ultimate elongation 250% minimum ASTM D-412 Specific gravity 1.4 maximum ASTM D-792 Water absorption 0.5% maximum ASTM D-570 Hardness, Shore D 35 5 ASTM D-2240 Flammability Pass ASTM D-635 Corrosion resistance Pass MIL-I-81765 Low temperature flex Pass MIL-I-81765 4 hours at 67 2F (-55 1C) Heat resistance 200% ultimate elongation, MIL-I-81765 168 hours at 347 2F minimum (175 1C) 1000 psi (6.9 Mpa) tensile strength, minimum Heat shock No cracking, dripping or MIL-I-81765 4 hours at 437 5F (225 flowing 2C) Elastic Memory 275% minimum expansion to 4 inch (10 cm) of a fully recovered test specimen, and 93% recovery of expanded specimen after oven condition for 1 minute at 302 4F (150 2 C) Electrica 200 v/mil (7880 v/mm) Dielectric strength minimum ASTM D-149 l 12 Volume resistivity 10 ohm-cm minimum ASTM D-257 200% ultimate elongation, MIL-I-81765 Chemical minimum Fluid Resistance 750 psi (5.2 Mpa) tensile strength, minimum shrinkHOoP is a Trademark of Tyco Electronics Specification Control Drawing Rev. Date: Rev.: Document No. Sheet: Dec. 9, 2004 F 2 of 2 URHR-1-and-5 If this document is printed it becomes uncontrolled. Check for the latest revision.