Application Specification 114-13206 ELCON* Drawer Series Connectors 19 JUL 13 Rev E NOTE NOTE All numerical values are in metric units with U.S. customary units in brackets . Dimensions are in millimeters and inches . i Unless otherwise specified, dimensions have a tolerance of 0.13 .005 and angles have a tolerance of 2. Figures and illustrations are for identification only and are not drawn to scale. 1. INTRODUCTION This specification covers the requirements for application of ELCON Drawer Series Connectors: True Hot Plug, Blind Mating Mixed Signal and Power Connectors. These connectors are designed for use in pluggable wire-to- board applications of power supplies. The connectors are available in a variety of custom configurations. The pin side connector accepts pin contacts, and the socket side connector accepts socket contacts. The contact cavities on both sides of the connector are marked for circuit identification. The high power connectors are available with or without pre-installed guide pins mid and low power connectors are designed with molded-in guide posts to ensure positive mating of connectors. The molded-in pin protectors prevent damage to the contacts. These features (including the guide pin holes and guide post cavities) have chamfered edges for ease of mating. The connectors are designed for float-mount and fixed-mount applications to allow blind mating with misalignment. All connectors are also designed with standoffs to allow easy printed circuit (pc) board cleaning after soldering. The contacts accept wire sizes 24 through 1/0 AWG. Contact sizes 20, 16, and 12 are available in crimp type, and solder type terminations. In addition, contact size 12 is available in hot plug, specifically designed for current interruption capability. Contact size 0 and 4 is available in crimp type termination, internal thread and external thread for ring lug mounting and bus bar mounting. Pin contacts (except size 0 and 4) are available in three lengths: standard, pre mate, and post mate for flexibility in contact sequencing. The contacts contain an active element, or crown band, which ensures maximum surface contact area, allows even insertion and withdrawal forces, and provides shock and vibration resistance. The contacts are available in loose piece only. Only crimp type and threaded contacts are removable. When corresponding with TE Connectivity Personnel, use the terminology provided in this specification to facilitate your inquiries for information. Basic terms and features of this product are provided in Figure 1. Top Drawer 75 Amp Middle Drawer Socket Side Pin Side Pin Side Socket Side Chamfered Edge Chamfered Edge Mounting Flange Contact Cavities Pin Protector Standoffs Guide Pin Hole Guide Post Guide Post Cavity Guide Pin Figure 1 (Contd) 2013 Tyco Electronics Corporation, a TE Connectivity Ltd. company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change. 1 of 17 All Rights Reserved PRODUCT INFORMATION 1-800-522-6752 For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners. 114-13206 Lower Drawer Mini Drawer Chamfered Edge Pin Side Socket Side Pin Side Socket Side Mounting Flange Contact Cavities Pin Protector Standoffs Guide Post Cavity Guide Post Chamfered Edge Dual Power Quad Power Pin Side Socket Side Pin Side Socket Side Mounting Flange Contact Cavities Pin Protector 125 Amp Middle Drawer Double Drawer Socket Side Pin Side Pin Side Socket Side Mounting Flange Contact Cavities Pin Protector Crimp Type Contact Size 0 Solder Type Contact Contact Crimp Type Internal Thread External Thread Figure 1 (End) 2. REFERENCE MATERIAL 2.1. Revision Summary Updated document to corporate requirements and added new logo Rev E 2 of 17