InstructionSheet HighCurrentExtractionTools 408--4174 679916-1,679917-1,and679918-1 11 MAR 10 Rev A 2. Holding the handle, insert the sleeve into the housing cavity until the sleeve bottoms. Allow the Push Rod push rod to slide out of the handle. Push Rod 3. While holding the sleeve in position, depress the Button push rod button. The contact will emerge from the Sleeve wire end of the housing as the button is depressed then pull contact free from housing. Handle If contact is not easily removed, carefully repeat NOTE the extraction procedure. Figure 1 i 1. INTRODUCTION (SeeFigure1) High Current Extraction Tools 679916--1, 679917--1, 4. MAINTENANCEANDINSPECTION and 679918--1 are designed to remove High Current It is recommended that the tool be inspected when Pin and Socket Contacts 193837-- and 193673-- you receive it and at regularly scheduled intervals. from their housings. Read these instructions The tool is not repairable, and it should be replaced thoroughly before using the tool. when it is worn or damaged. Store the extraction tool Housings are customer supplied and must be NOTE in a clean, dry place and clean the extraction tool with designed to meet specifications by Tyco a soft, lint--free cloth. Electronics. i Order extraction tools through your Representative, or call 1--800--526--5142, or send a facsimile of your purchase order to 1--717--986--7605, or write to: 2. DESCRIPTION CUSTOMER SERVICE (38--35) The extraction tool consists of a push rod button, TYCO ELECTRONICS CORPORATION push rod, handle, and sleeve. The sleeve is inserted PO BOX 3608 into the mating face of the housing, depressing the HARRISBURG PA 17105--3608 locking lances of the crimped contact and allowing the contact to be extracted from the wire end of the housing. 5. REVISIONSUMMARY 3. EXTRACTIONPROCEDURE (SeeFigure2) Revisions to this instruction sheet include: S Updated instruction sheet to corporate 1. Align the sleeve of the tool with the contact to be removed. requirements Housing (Customer Supplied) Housing Locking Lance(s) Cavity of Pin Contact Wire End Push Rod of Housing (Extended) Figure 2 E2010TycoElectronics Corporation, Berwyn, PA TOOLING ASSISTANCE CENTER1--800--722--1111 This controlled document is subject to change. 1 of 1 PRODUCT INFORMATION1--800--522--6752 Forlatest revision and Regional CustomerService, All Rights Reserved visit ourwebsite atwww.tycoelectronics.com TE logo and Tyco Electronics are trademarks. LOCB *Trademark. Otherproducts names, logos, orcompany names might be trademarks of theirrespective owners.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Hand Tools category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : 568681-1 576786-2 58061-1 58176-1 58177-1 58177-2 58284-1 59085 0031 59737-5 015-0339-000 015-8755-001 600-146-06 M15570- 25 62200-5709 6-304052-1 63443-1002 63443-3513 63443-4025 63443-7114 6-354778-5 6-354779-2 63600-2995 63810-0105 M8196914-08 M819698-07 662508-1 662908-1 679994-1 679994-2 68764-0001 69001-0105 69002-5525 690124-7 690191-1 690191-4 690696-1 691409-4 691667-1 692006-2 692655-7 692776-1 692776-4 693077-3 693077-4 693597-1 D20418-137 D20419-189 ESR- 17x17 ET-LY10