91124-1 TE Connectivity

Instruction Sheet Extraction Tool 91124-1 408-7807 for Type XII Contacts 11 MAY 11 Rev A Wire Locking Latch (Typ) Male Contact (Ref) Tool Tips Connector Mating Face Tool Tips Cavity Offsets Contact Handle Figure 2 Figure 1 4. TOOL CERTIFICATION Extraction Tool 91124-1 should be certified and must 1. INTRODUCTION conform to the dimensions in Figure 3. Extraction Tool 91124-1 is designed for removing both It is recommended that the tool be inspected male and female Type XII contacts from various immediately upon arrival in your factory to assure that connectors. Read these instructions thoroughly before the tool has not been damaged during shipping and extracting any contacts. handling, and at regularly scheduled intervals., Dimensions are in metric units with inches in NOTE Additional tools can be purchased from: brackets . Illustrations are not drawn to scale. i CUSTOMER SERVICE (038-035) TYCO ELECTRONICS CORPORATION PO BOX 3608 2. DESCRIPTION HARRISBURG PA 17105-3608 This tool features a plastic handle with two metal tool tips for releasing the contact locking latches (see 5. REVISION SUMMARY Figure 1). Since the previous release of this instruction sheet, the new company logo has been applied. 3. EXTRACTION PROCEDURES The following procedures apply to both male and female contacts and to all connectors that accept 7.112 these contacts. Refer to Figure 2 and proceed as .280 follows: 1. Align tool tips with contact cavity offsets on mating face of connector. 0.660 2. Insert tips straight into cavity until they bottom026 120.142 The locking latches are now released. 4.73 24.231 NOTE .954 i 3.0232 .119 25.146 3. Holding tool in position grasp wire and puII .99 Dia contact straight out BACK of connector. 4. Remove tool from cavity. Figure 3 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change. 1 of 1 All Rights Reserved PRODUCT INFORMATION 1-800-522-6752 For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com LOC B TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Extraction, Removal & Insertion Tools category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : M8196914-08 768211-2 809-131 844751-2 8-59558-2 91018-1 12014013 12093647 1-21048-0 R282867020 12093078 1-21048-6 12121897 DCF.91.405.5LT 1322 15314260 15350698 15350707 15430130 1579018-4 1643916-1 1-679532-0 1976593-3 OUTEXT-0321 2-1579008-3 2-1579008-4 229694-7 231106-1 241469 91040-3 91040-7 965004-000 965069-000 1738219-1 ET-JL05-16 FG 0300 146 3000 FIT-6 210S048 2-1579007-9 231879-1 312138-3 RJ11FODE 356-162 M8196914-10 4-1579018-0 430395-001 483249-1 5- 1579007-2 5-1579007-9 BPR10