URHT Ultra-high Ratio Heat-Shrink Tubing Table 1: Dimensions, inch (mm) PART Unrestricted Full (A) (B) (C) Ref. Recd. DESCRIPTION Recovered Length (D) Min. Exp. ID Max. Recd. ID Wall Thickness (See Adhesive) .25 (6) URHT-200 2.00 (51) 0.23 (6) 0.14 (3.5) 3, 4, 6, 10 (76, 102, 152, 254) URHT-300 3.00 (76) 0.34 (9) 0.14 (3.5) 3, 4, 6, 10 (76, 102, 152, 254) Material: Flame retarded, black, cross linked polyolefin. Adhesive (optional): Factory hot melt adhesive may be applied. Specify adhesive type number /42 (e.g. URHT-200/4/42-0). Customer Drawing Tyco Electronics Title: Raychem Corporation URHT 305 Constitution Drive Tubing Menlo Park, CA 94025 Ultra-High Ratio Heat-Shrink Tubing USA Tyco Electronics reserves the right to amend this drawing at any time. Document No. Users should evaluate the suitability of the product for their URHT-X application. UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. Rev: Rev. Date: METRIC DIMENSIONS ARE SHOWN IN BRACKETS. E November 13, 2007 DRAWN BY: CAGE CODE: Org. Date: File name: SCALE: SIZE: SHEET: U.NGUYEN 06090 URHT-X.doc None A 1 of 2 01/09/02 2004-2007 Tyco Electronics Corporation. All rights reserved If this document is printed it becomes uncontrolled. Check for the latest revision. Table 2: Properties Property Performance Test Method Physical Tensile Strength 1200 psi (8.3 Mpa) minimum ASTM D-412 Ultimate Elongation 250% minimum ASTM D-412 Specific Gravity 1.4 maximum ASTM D-792 Water Absorption 0.5% maximum ASTM D-570 A Hardness 35 5 Shore D ASTM D-2240 Flammability Pass ASTM D-635 Corrosion Resistance Pass MIL-I-81765 Low Temperature Flexibility Pass MIL-I-81765 4 hours at 67 2F (-55 1C) Heat Resistance Ultimate elongation, 200% minimum MIL-I-81765 168 hours at 347 2F (175 Tensile strength, 1000 psi (6.9 Mpa) 1C) minimum Heat Shock No cracking, dripping or flowing MIL-I-81765 4 hours at 437 5F (225 2C) 275% minimum expansion to 4 inch (10 cm) of a fully Elastic Memory recovered test specimen and 93% recovery of expanded specimen after oven conditioning for 1 minute at 302 4F (150 2C) Electrical Dielectric Strength 200 v/mil (7880 v/mm) minimum ASTM D-149 12 Volume Resistivity 10 ohm-cm minimum ASTM D-257 Ultimate elongation, 200% minimum Chemical Fluid Resistance MIL-I-81765 Tensile strength, 750 psi (5.2 Mpa) minimum -131 to + 275F (-55 to +135 C) without adhesive Operating Temperature Customer Drawing Rev. Date: Rev: Document No. Sheet: E 2 of 2 November 13, 2007 URHT-X If this document is printed it becomes uncontrolled. Check for the latest revision.