SPECIFICATION CONTROL DRAWING Product Revision Usable Wire or Component Diameters (4) Wire Designation A min B min Product Name C D D-112-1222-9 N/C MIL-W-22759/32-22-9 D-112-1224-9 N/C MIL-W-22759/32-24-9 0.71 2.33 0.25 to 0.60 0.75 to 2.30 (0.028) (0.092) (0.010 to 0.025) (0.030 to 0.090) D-112-1622 N/C Solder Plated Bus Wire D-112-1830-9 N/C MIL-W-81822/13-30-9 D-112-2222-9 N/C MIL-W-22759/32-22-9 1.11 3.00 0.50 to 1.07 0.75 to 3.00 D-112-2622 N/C Solder Plated Bus Wire (0.044) (0.118) (0.020 to 0.042) (0.030 to 0.118) D-112-2830-9 N/C MIL-W-81822/13-30-9 D-112-3222-9 N/C MIL-W-22759/32-22-9 1.24 3.94 0.80 to 1.14 1.40 to 3.90 D-112-3622 N/C Solder Plated Bus Wire (0.050) (0.155) (0.032 to 0.045) (0.055 to 0.153) D-112-3830-9 N/C MIL-W-81822/13-30-9 Dimensional Notes: (a) Dimension is to top shoulder (wire stop) of sleeve. Position of lead relative to solder preform and shoulder may vary from diagram. (b) Lead length for sleeves with bus wire is 27.94 min. (1.10 min.) overall with 12.7 min. (0.50 min) extension from end of sleeve. MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn63 per ANSI/J-STD-006. FLUX: TYPE ROL1 per ANSI/J-STD-004. 3. MELTABLE INSERT: Polyolefin-based thermoplastic. Color: blue. 4. PRE-INSTALLED LEAD: See table. APPLICATION 1. The parts covered by this document are used to attach the pre-installed lead to another electrical conductor such as component leads, coaxial cable primary, insulated wire or connector terminals. Insulated leads and coax dielectric must be rated for at least 125C. 2. Spliced assemblies will meet the performance requirements of Tyco Electronics/Raychem specification RT-1404 when installed on solderable components using a Tyco Electronics/Raychem approved convection or infrared heater and reflector. For best results, prepare the wire(s) as shown: Component Lead Coax Cable or Insulated or Terminal Wire Conductor TITLE: SOLDERSLEEVE SPLICES WITH 305 Constitution Drive, Menlo Park, CA. 94025, USA PRE-INSTALLED LEADS, SERIES D-112 DOCUMENT NO.: Unless otherwise specified dimensions are in millimeters. Inches dimensions are shown in brackets. D-112-1XXX / -3XXX Series TOLERANCES: ANGLES: N/A Tyco Electronics reserves the right to amend 0.00 N/A this drawing at any time. Users should PROD. REV.: DOC. ISSUE: DATE: 0.0 N/A ROUGHNESS IN evaluate the suitability of the product for their SEE TABLE 3 18-Feb-03 0 N/A MICRON application. PREPARED BY: DCR NUMBER: REPLACES: SCALE: SIZE: SHEET: mforonda D030064 D020199 None A 1 of 1 If this document is printed it becomes uncontrolled. Check for the latest revision. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Solder & Shield Tubing category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : CTC-0062-20-9/5-9 CTC-0062-22-9/5-9 650076N001 680441-000 D-150-0331CS2902 D-181-1222-90/9CS2800 D-300-01CS1108 982127- 1 D-436-0127CS391 D-436-0182CS246 D-436-37CS2651 D-436-58CS246 D-436-61CS246 D-436-82-CS2621 D-659-0087 D-750- 0005CS2493 E53797N001 S200-2-01 S200-4-00CS2904 LSS-81-16AA-CS5575 SO63-2-9036-22CS2677 SO63-3-01CS293 SO63-3-9036- 20CS2677 SO63-3-9036-22CS2677 SO63-4-9036-20CS2677 SO63-5-9036-22CS2677 CC1525-000 CTA-0025 CTA-0025CS072 D-108- 01CS227 D-108-07CS436 D-128-0010 D-141-0108CS404 D-142-51-202-7754 D-144-41CS1371 D-150-0231-NRCS2896 B-801-18-01 B- 801-58 515-9 D-436-36CS2908 D-436-37CS2908 D-436-52CS246 D-436-83CS2705 D-438-0102 LSS-26-8A 427243-000 D-106-2012 D- 300-08CS1108 UWCS-2U/7.6-1C/5.8 620026-000