1 4 1. Tubing: -50, -51. resin adhesive, refer to supplementary information on Safety Data Heat-shrinkable polymeric products for applications including primary electrical insulation, cable jacketing and repair, and environmental/mechanical protection. Cheney Manor Industrial Estate United Kingdom (44) 1793-573824 Day: (32) 14-584545 Night: (32) 14-584545 2. 3. This Safety Data Sheet applies to a group of products which are not hazardous as supplied, but which may emit hazardous thermal 4. EYES If molten material contacts the eyes, flush with water for at least 15 minutes, holding eyelids open. Seek medical attention. If molten material contacts the skin, cool immediately with cold water. Treat as a burn. Do not attempt to remove material adhering to the skin. Seek medical attention. Seek medical attention. Move to fresh air. Keep warm and at rest. Seek medical attention if breathing problems develop. INHALATION INGESTION SKIN FIRST AID MEASURES decomposition products (refer to section 10). HAZARDS IDENTIFICATION adhesive. may be coated with Raychem Unicure-225 precatalysed epoxy resin copolymers, fluoropolymers, polyamides and polyesters. Products Plastic materials may be based on polyethylene and olefin CHEMICAL DESCRIPTION ON ON INGREDIENTS COMPOSITION/INFORMATI Emergency Telephone Telephone Swindon SN2 2QS IDENTIFICATION Raychem Ltd COMPANY/UNDERTAKING APPLICATION Sheet RAY/3111E. For products coated with Raychem Unicure-225 precatalysed epoxy Moulded Parts Type: FRAG, PRDM, T-DR-25, ZHCP. ATO99, DR-25, DR-25-TW, DTMS, Thermofit Heat-Shrinkable Polymeric Products: PRODUCT IDENTIFICATION OF SUBSTANCE OR PREPARATION of Page Reference RAY/3137E Raychem Safety Data Sheet2 4 5. Fire fighters should wear self-contained breathing apparatus with full 6. Pick up for re-use or disposal. 7. Cool, dry warehouse environment. Store in original packaging and away from direct sunlight. Use local exhaust ventilation of the workplace. If using gas torches in depletion. Refer to Raychem product installation instructions. Avoid overheating the product after shrinkage has occurred. If the product blisters, chars or shows any other signs of degradation, stop heating immediately. Avoid inhaling fumes which may be released from hot plastic. Wash hands at the end of work and before eating, drinking or smoking. 8. Not applicable to products as supplied. Small amounts of substituted aromatic isocyanates may be released during installation. Name LTEL (8-hour TWA) (15-minute) -3 -3 0.02 mg m 0.07 mg m Not required under normal circumstances. Use respiratory protective equipment if ventilation is inadequate to control exposure. Heat resistant gloves may be required to manipulate hot products after installation. EYE Safety glasses/goggles or face shield, depending on the application. HAND RESPIRATORY PERSONAL PROTECTIVE EQUIPMENT EH40/95 MEL Isocyanates, all (as NCO) Ref. Type STEL OCCUPATIONAL EXPOSURE LIMITS EXPOSURE CONTROLS/PERSONAL PROTECTION (NORMAL USE) HANDLING confined spaces, ensure an adequate supply of fresh air to avoid oxygen VENTILATION STORAGE STORAGE AND HANDLING (IN NORMAL USE) RECOVERY Not applicable. ENVIRONMENTAL PRECAUTIONS Not applicable. PERSONAL PRECAUTIONS ACCIDENTAL RELEASE MEASURES (SPILLAGE) facepiece and protective clothing. PROTECTIVE MEASURES Toxic fumes may be evolved in a fire. FIRE AND EXPLOSION HAZARDS Water fog, dry powder, carbon dioxide, foam. EXTINGUISHING MEDIA FIRE FIGHTING MEASURES of Page Reference RAY/3137E Raychem Safety Data Sheet