SAS-300-1-1030-0 TE Connectivity

INTERCONNECT No: SAS-XXX-X-1030 Thermofit Tubing Slit Adhesive Sleeve Specification Control Drawing Rev: C Date: February 3, 2000 Page: 1 of 3 Slit Adhesive Sleeve (S-1030) Table 1: Dimensions (inches) Size Extruded ID (A) Cut Length (B) Extruded Wall (C) SAS-090-1-1030 .090 .005 1.000 .050 0.022 .003 SAS-115-1-1030 .115 .005 1.000 .050 0.030 .003 SAS-160-1-1030 .160 .005 1.000 .050 0.030 .003 SAS-200-1-1030 .200 .005 1.000 .050 0.033 .003 SAS-250-1-1030 .250 .005 1.000 .050 0.033 .003 SAS-300-1-1030 .300 .005 1.000 .050 0.060 .003 Color: Black If this document is printed it becomes uncontrolled. Check for the latest revision. INTERCONNECT No: SAS-XXX-X-1030 Thermofit Tubing Slit Adhesive Sleeve Specification Control Drawing Rev: C Date: February 3, 2000 Page: 2 of 3 Table 2: Properties Property Unit Requirements Test Method Physical Visual -- No foreign matter, voids, pinholes. Specific Gravity -- 1.00 0.05 ASTM D 792 Low Temperature C -70 maximum ASTM D 746 Impact Brittleness Procedure B Adhesive Peel lbs/in width Note 1 Polyolefin 25 minimum Polychloroprene 25 minimum Chemical* Water Absorption Percent 1.0 maximum ASTM D 570 Fungus Resistance -- Rating of 1 or less ASTM G 21 Electrical* 10 Volume Resistivity ohm-cm 10 minimum ASTM D 257 Dielectric Strength V/mil 500 minimum ASTM D 149 *Test specimens shall be prepared in the form of 6 x 6 x 6 x .075-inch compression molded slabs. Molding temperature shall be 140C (285F). Acceptance Tests: Visual, Dimensions, Specific Gravity If this document is printed it becomes uncontrolled. Check for the latest revision.