SR1E Cable Actuated Sensor Industrial Incremental Encoder Output Linear Position up to 175 inches (3 meters) 0-125, 0-175 inch Full Stroke Range Options Designed for Outdoor & IP67 environments In Stock for Quick Delivery 175-inch model shown Specifications Full Stroke Range, SR1E-125 125 inches (3175 mm) Full Stroke Range, SR1E-175 175 inches (4445 mm) Output Signal incremental encoder Resolution 101 2 pulses per inch Accuracy .1% FS. Repeatability .05% FS. Input Voltage 5-30 VDC The SR1E is rugged, low-cost, high performance Input Current 100 mA max., no load string pot built to withstand wet environments and outdoor applications. Designed for construction Sensor incremental encoder equipment and factory use, the SR1E is the perfect Output Driver Type push-pull (note: Vin = Vout) low-cost solution for OEM and stocking distributors. Output Driver Current 20 mA max., source/sink At the heart of this sensor is a robust incremental Maximum Velocity 80 inches (2 meters) per second encoder that delivers a linear resolution of 101 Maximum Acceleration 10 g (retraction) pulses per inch. The SR1E ships with an industry Measuring Cable Tension 23 oz. (6,4 N) 30% standard push-pull encoder driver that can be powered by 5-30 VDC. (Other resolutions and Enclosure polycarbonate complimentary channels are available, please Measuring Cable .034-inch dia. nylon-coated stainless consult factory). Each sensor ships with a 4-pin, field installable, M12 connector and an additional Electrical Connection M12 Connector (mating plug included) 13 ft. (4 m) cordset is also available. Just like the Environmental Suitability NEMA 6, IP67 rest of our SR1 series, the SR1E is in stock for Operating Temperature -4 to 185 F (-20 to 85 C) quick delivery. Weight 2.5 lbs. (1.3 Kg) Output Signal SENSOR SOLUTIONS /// SR1E 12//2015 Page 1 SR1E Industrial Incremental Encoder Electrical Connection Field Installable Connector Cord Set Connections Cable Exit Direction Options Changing the Cable Exit Changing Measuring Cable Exit To change the direction of the measuring cable, remove the 4 mounting bracket screws and rotate bracket to one of four available positions. See figures 1 - 4 on the following pages for mounting dimensions. Changing Electrical Connector Direction To change the position of the electrical connector, remove the 4 rear cover screws and carefully separate rear cover from the sensor body. Rotate the rear cover to desired position being careful to not tangle the wiring harness that runs to the connector. SENSOR SOLUTIONS /// SR1E 12//2015 Page 2