TRSA-1010/C/1/0 TE Connectivity

RK 6743 Revision 4 Page 1 of 7 Date Printed 31-Mar-14 RK 6743 Revision 4 TRSA Sleeving SCOPE This Quality Assurance Specification establishes the quality standard for a heat-shrinkable, flexible polyolefin sleeving. Approved Signatories* * This document is electronically reviewed and approved - therefore no signatures will appear. If this document is printed it becomes uncontrolled. Check latest revision in DMTEC /Intranet on the nearest PC RK 6743 Revision 4 Page 2 of 7 Date Printed 31-Mar-14 1. REVISION HISTORY Revision Change Request Date Incorporated By Number 2 CR98-DM-0199 24 September 1998 L. Abrams 3 Via DMTEC 31 March 2014 C. Diss 4 Via DMTEC 31 March 2014 C. Diss 2. REQUIREMENTS 2.1 Composition, Appearance and Colour The sleeving shall be homogeneous and free from pinholes, bubbles, cracks and inclusions. The colour shall be as specified in the contract or order. 2.2 Dimensions Size Inside Diameter as Inside Diameter after Wall Thickness after supplied (min) recovery (max) recovery mm mm mm 1.5/0.5 1.5 0.5 0.45 0.10 3/1 3.0 1.0 0.55 0.10 6/2 6.0 2.0 0.65 0.10 9/3 9.0 3.0 0.75 0.12 12/4 12.0 4.0 0.75 0.12 Sleeving of special expanded or recovered dimensions may be supplied as specified in the contract or order. 2.3 Test Requirements The test requirements shall be as specified in Table 1. 3. TEST METHODS 3.1 Unless otherwise specified, tests shall be carried out on specimens of sleeving recovered by conditioning in a fan assisted air circulating oven at 200 5C for 4 1 minutes and allowed to cool in air to ambient temperature. No pre-conditioning period is required prior to testing. Unless otherwise specified, all tests shall be made under standard ambient conditions according to IEC Publication 212. In cases of dispute the tests shall be carried out at a temperature of 23 2C and at 50 5% relative humidity. 3.2 Dimensions and Longitudinal Change The test method shall be as specified in ASTM D2671. The length and inside diameter of three 150mm long specimens of expanded sleeving shall be measured. The specimens shall be recovered in a fan assisted air circulating oven and the length and inside diameter of each shall be measured. The longitudinal change shall be expressed as a percentage of the original length. The minimum and maximum recovered wall thickness shall be determined. If this document is printed it becomes uncontrolled. Check latest revision in DMTEC /Intranet on the nearest PC