2651A-KIT-3 Tektronix

Model 2651A-KIT Keithley Instruments, Inc. High-Current Cable Kit 28775 Aurora Road Cleveland, Ohio 44139 1-888-KEITHLEY Model 2651A-KIT Use this cable with the Model CS-1626-2 termination block to connect the Model 2651A to a device under test (DUT): 1. Use insulated cable wires (12 gauge or thicker) to connect the Model CS-1626-2 termination block to the DUT. 2. Twist the cable wire pair to minimize inductance. 3. Plug one end of the Model 2651A-KIT cable into the Model CS-1626-2 termination block. 4. Plug the other end of the Model 2651A-KIT cable into the OUTPUT connector on the Model 2651A. Use this cable with the Model CS-1626-2 termination block to connect the Model 2651A to the Model 8011 High Current Test Socket Kit: 1. Connect the unterminated ends of banana-plug cable wires to the screw terminals of the Model CS-1626-2. Unterminated banana-plug cables are available from Keithley Instruments (Model CA-567). 2. Twist the cable wire pair together to minimize inductance, and then plug the cables into the binding posts of the Model 8011 test socket board. 3. Plug one end of the Model 2651A-KIT cable into the Model CS-1626-2 screw terminal block. 4. Plug the other end of the cable into the OUTPUT connector on the Model 2651A. Electrical characteristics 3.28 ft (1 m) 6.56 ft (2 m) 9.84 ft (3 m) Rated voltage and current 350 V maximum, 40 A Operating environment -40 C to +90 C Electrical impedance 6 DC resistance 11 m 17 m 24 m Inductance at 1 KHz 220 nH 320 nH 420 nH Inductance at 100 KHz 195 nH 265 nH 340 nH Cable diameter 0.217 in. (5.5 mm) 2 PA-1038 Rev. A / December 2011