TB6552FTG,8,EL Toshiba

TB6552FNG/FTG Toshiba Bi-CD Integrated Circuit Silicon Monolithic TB6552FNG, TB6552FTG DUAL-BRIDGE DRIVER IC FOR DC MOTORS The TB6552FNG/FTG is a dual-bridge driver IC for DC motors TB6552FNG with output transistors in an LD MOS structure with low ON-resistance. Two input signals, IN1 and IN2, can choose one of four modes such as CW, CCW, short brake, and stop mode. A PWM drive system supports high heat efficiency driving. Features Power supply voltage for motor: VM 15 V (max) Power supply voltage for control: V = 2.7 V to 6.0 V CC TB6552FTG Output current: 1 A (max) Low ON resistor: 1.5 (typ.) (Upper side + lower side combined VM = 5 V) Direct PWM control Standby system (power saving) CW/CCW/short brake/stop function modes Built-in thermal shutdown circuit P-WQFN16-0303-0.50-001 Package: FNG-SSOP16/FTG-WQFN16 Weight SSOP16-P-225-0.65B : 0.07 g (typ.) P-WQFN16-0303-0.50-001 : 0.017 g (typ.) * This product has a MOS structure and is sensitive to electrostatic discharge. When handling this product, ensure that the environment is protected against electrostatic discharge by using an earth strap, a conductive mat and an ionizer. Ensure also that the ambient temperature and relative humidity are maintained at reasonable levels. 2014-2017 1 2017-08-08 Toshiba Electronic Devices & Storage Corporation TB6552FNG/FTG Block Diagram V BIN1 BIN2 BPWM BSTBY BO1 BO2 VM CC Control logic (Ch. B) Bridge Driver (Ch. B) TSD Bridge Driver Control logic (Ch. A) (Ch. A) PGND GND AIN1 AIN2 APWM ASTBY AO1 AO2 Pin Functions Pin No Pin.Name Functional Description Remarks FNG FTG GND 1 11 Small-signal GND pin GND for small-signal power supply (V ) CC AIN1 2 12 Control signal input 1 (Ch. A) AIN2 3 13 Control signal input 2 (Ch. A) PWM control signal input pin APWM 4 14 Input PWM signal (Ch. A) Standby control input pin Ch. A circuit is in standby (power save) state ASTBY 5 15 (Ch. A) while this signal is Low. AO1 7 1 Output pin 1 (Ch. A) Ch. A connect to motor coil pin AO2 8 2 Output pin 2 (Ch. A) Ch. A connect to motor coil pin PGND 9 3 GND pin for motor GND for motor power supply (VM) VM 6 16 Motor power supply pin VM = 2.5 V to 13.5 V (ope) BO2 10 4 Output pin 2 (Ch. B) Ch. B connect to motor coil pin BO1 11 5 Output pin 1 (Ch. B) Ch. B connect to motor coil pin Standby control input pin Ch. B circuit is in standby (power save) state BSTBY 12 6 (Ch. B) while this signal is Low. PWM control signal input pin BPWM 13 7 Input PWM signal (Ch. B) BIN2 14 8 Control signal input 2 (Ch. B) BIN1 15 9 Control signal input 1 (Ch. B) Small-signal power supply V 16 10 V = 2.7 V to 5.5 V CC CC (ope) pin 2 2017-08-08