TLP2361(TPRE Toshiba

TLP2361 Photocouplers GaAAs Infrared LED & Photo IC TLP2361TLP2361TLP2361TLP2361 1. 1. ApplicationsApplications 1. 1. ApplicationsApplications Factory Networking High-Speed Digital Interfacing for Instrumentation and Control Devices I/O Interface Boards 2. 2. 2. 2. GeneralGeneralGeneralGeneral The Toshiba TLP2361 consists of a high-output GaAAs light-emitting diode coupled with integrated high gain, high-speed photodetectors. It is housed in the SO6 package. This photocoupler guarantees operation at up to 125 and on supplies from 2.7 V to 5.5 V. Since TLP2361 has guaranteed 1 mA low supply current (I /I ), and 1.6 mA (T = 125 ) low threshold input current(I ), it CCL CCH a FHL contributes to energy saving of devices. It can drive directly from a microcomputer for a low input current. The TLP2361 has an internal Faraday shield that provides a guaranteed common-mode transient immunity of 20 kV/s. 3. 3. FeaturesFeatures 3. 3. FeaturesFeatures (1) Inverter logic type (Totem pole output) (2) Package: SO6 (3) Operating temperature: -40 to 125 (4) Supply voltage: 2.7 to 5.5 V (5) Data transfer rate: 15 MBd (typ.) (NRZ) (6) Threshold input current: 1.3 mA (max) ( T = 105 ) a : 1.6 mA (max) ( T = 125 ) a (7) Supply current: 1.0 mA (max) (8) Common-mode transient immunity: 20 kV/s (min) (9) Isolation voltage: 3750 Vrms (min) (10) Safety standards UL-approved: UL1577, File No.E67349 cUL-approved: CSA Component Acceptance Service No.5A File No.E67349 (Note 1) VDE-approved: EN60747-5-5 (Note 1)(Note 1)(Note 1) CQC-approved: GB4943.1, GB8898 Thailand Factory Note 1: When an EN60747-5-5 approved type is needed, please designate the Option (V4)Option (V4)Option (V4)Option (V4). Start of commercial production 2013-06 2015 Toshiba Corporation 2015-11-02 1 Rev.5.0TLP2361 4. 4. 4. 4. Packaging and Pin ConfigurationPackaging and Pin ConfigurationPackaging and Pin ConfigurationPackaging and Pin Configuration 1: Anode 3: Cathode 4: GND 5: V (Output) O 6: V CC 11-4L1S 5. 5. 5. 5. Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note) Note: A 0.1-F bypass capacitor must be connected between pin 6 and pin 4. 6. 6. Principle of OperationPrinciple of Operation 6. 6. Principle of OperationPrinciple of Operation 6.1. 6.1. 6.1. 6.1. Truth TableTruth TableTruth TableTruth Table Input LED Output H ON L L OFF H 6.2. 6.2. Mechanical ParametersMechanical Parameters 6.2. 6.2. Mechanical ParametersMechanical Parameters Characteristics Min Unit Creepage distances 5.0 mm Clearance distances 5.0 Internal isolation thickness 0.4 2015 Toshiba Corporation 2015-11-02 2 Rev.5.0