MFP1-5603JR TT Electronics

Flameproof Power Metal Film Resistor MFP Series Flameproof protection Small size for power rating Electrical Data Power Limiting Resistance Resistance Thermal Ambient IRC Rating Element TCR Standard Range Tolerance* Impedance Temperature Type 70C Voltage (ppm/C) Values (watts) (%) (C/watt) (C) (watts) (volts) MFP05 0.5 7R5 - 15R0 100 150 <1 ohm: 300 <1 ohm: 0.7 E24 MFP1 0.1 - 1M 350 1 ohm-9.1 ohm: 200>10 1, 2, 5 120 -55 to 155 >1 ohm: 1.0 preferred ohm: 100 MFP2 2 1R0 - 1M 100 82 * Below 1 ohm 5% TOL preferred. Environmental Data Characteristic Maximum Load: 1000 hours at 70C R 5 Shelf Life: 12 months at room temperature R 2 Derating from rated power at 70C R zero at 155C Climatic R 3 Climatic Category 50/155/56 R Temperature rapid change 0.5 R Resistance to solder heat R 0.5 Voltage proof volts 500 min General Note IRC reserves the right to make changes in product specication without notice or liability. All information is subject to IRCs own data and is considered accurate at time of going to print. A subsidiary of TT electronics plc Wire and Film Technologies Division 4222 South Staples Street Corpus Christi Texas 78411 USA Telephone: 361 992 7900 Facsimile: 361 992 3377 Website: www.irctt.com MFP Series Issue October 2008 Sheet 1 of 3Flameproof Power Metal Film Resistor Physical Data d D L f Dimensions (mm) and Weight (g) IRC PCB mounting Min. Bend L max D max f min d nom Wt. nom Type centers Radius MFP05 3.5 1.8 22.4 0.5 7.6 0.5 0.1 MFP1 6.2 2.3 21.0 0.6 10.2 0.6 0.3 MFP2 10.0 4.0 19.0 0.8 18.4 1.2 0.55 Construction Marking The resistance element is a precisely controlled thin lm MF Series resistors are color coded with 4 or 5 bands depending of metal alloy on a high purity ceramic core, protected on value and tolerance. IEC colors are used. by a cement coating applied so that terminations remain completely clear. Solvent Resistance The body protection and marking are resistant to all normal This permits a well dened body length, (clean lead to industrial cleaning solvents suitable for printed circuits. clean lead dimension L). Flammability Terminations The resistors coating will not burn or emit incandescent particles Material Solder-coated copper wire. under any condition of applied temperature or power overload. Strength The terminations meet the requirements of IEC 68.2.21 Solderability The terminations meet the requirements of IEC 115-1, Clause 4.17.3.2 Wire and Film Technologies Division 4222 South Staples Street Corpus Christi Texas 78411 USA Telephone: 361 992 7900 Facsimile: 361 992 3377 Website: www.irctt.com MFP Series Issue October 2008 Sheet 2 of 3