PROBE60S Unbranded

IEC-1010 PROBE60S Oscilloscope Probe Kit Kit Oscilloscope Sonde ENGLISH Oscilloscope Probe Kit Introduction The PROBE60S is a passive high impedance oscilloscope probe designed and calibrated for use on instruments having an input impedance of 1 Mohm shunted by 25pF. However, it may be compensated for use with instruments having an input capacitance of 10 - 35 pF. The probe incorporates a two position slide switch in the head which selects attenuation of X1, X10 position. Maintenance Before dismantling any part of the probe, make sure it is disconnected from any voltage source. The probe head can be detached from the cable assembly by unplugging the push fit BNC connector on the probe head. This permits replacement of the cable or head assembly should either part become damaged. The measuring tip is also replaceable. To replace a broken tip, hold the black insulating part of the tip with pliers and pull it away from the probe head. Replace with a new tip taking care to align with the inner contact. Compensation Adjustment In order to obtain the correct division ratio with each oscilloscope, the attenuation network needs to be adjusted. To compensate the probe to your oscilloscope, apply a 1kHz square wave to the probe tip, or connect to the cal socket on the oscilloscope to display a few cycles of the waveform. And adjust the trimmer located in the BNC connector for a flat-topped square wave. Specifications Position x1 Attenuation Ratio 1:1 Bandwidth DC tot 15 MHz Rise Time 27 ns Input Resistance 1Mohm (oscilloscope input) Input Capacitance 46 pF plus oscilloscope capacitance Working Voltage 600 V DC incl. Peak AC derating with frequency Position x10 Attenuation Ratio 1:10 Bandwidth DC tot 60 MHz Rise Time 5.5 ns Input Resistance 10 Mohm when used with oscilloscopes with 1Mohm input Input Capacitance Approx. 18pF Compensation Range 10 to 35 pF Working voltage 600 V DC incl. peak-AC derating with frequency (see Fig. 1) Cable length 140 cm