PHASE ANGLE POWER PSR-25 25A ac X10205 CONTROL MODULE INTRODUCTION The PSR-25 Power Control Module is a high power, full wave AC phase angle controller in a compact package, capable of regulating up to 6KW (25A) 230V ac. The PSR-25 regulator governs the amount of power supplied to the load, by controlling the phase angle of the AC supply. The low thermal impedance and high electrical isolation provides the equipment designer with a greater flexibility in a wide variety of applications. APPLICATIONS Suitable for quartz lamps, conventional resistive heating elements, including ovens, moulders and dryers and some inductive loads (e.g. transformers and motors). FEATURES Solid state reliability. Epoxy encapsulated. Simple wiring. Rugged and compact High current capability. Internal snubber. INSTALLATION COOLING REQUIREMENTS INSTALLATION SPECIFICATIONS AC line voltage 110/230V +/- 10% 50/60 Hz Unit limiting RMS current 25A Peak one cycle surge (10ms) 250A Max peak voltage 600Vac 2 2 I t for fusing 250 A s Minimum operating current 200mA Isolation voltage 5000Vrms Leakage current 5mA Max. operating temperature 65C Manual potentiometer (nominal) 250K 1W 230Vac Storage temperature -20C to +85C Manual potentiometer (nominal) 100K 1W 110Vac FUSING: It is recommended to use semiconductor (fast acting) type fuses or circuit breakers (Semiconductor - MCB) for unit protection. (See SRA Datasheet for further information). CE MARKING This product family carries a CE marking. These phase angle type controllers require a suitable remote filter. For information see recommendation section and contact our sales desk. (See Declaration of Conformity). RECOMMENDATION Other documents available on request, which may be appropriate for your applications. CODE IDENTITY DESCRIPTION X10229 RFI Filtering recommendations - addressing the EMC Directive X10213 ITA Interaction, uses for phase angle and for burst fire control. X10255 SRA Safety requirements - addressing the Low Voltage Directive (LVD) including :- Thermal data/cooling Live parts warning & Earthing requirements Fusing recommendations. AP02/4 COS UAL Conditions of sale NOTE It is recommended that installation and maintenance of this equipment should be done with reference to the current edition of the I.E.E. wiring regulations (BS7671) by suitably qualified/trained personnel. The regulations contain important requirements regarding safety of electrical equipment. (For International standards refer to I.E.C directive IEC 950). ORDER CODE State part number: PSR 25 Optional extras include: Potentiometer, Filter, Heatsink paste, Heatsink assembly Note: When ordering a filter, the current the PSR is to be used at will be required. UNITED AUTOMATION LIMITED 1 Southport Business Park Tel (01704)-565713 Southport, PR8 4HQ, U.K. Fax (01704)-569760 Page No 2 of 2 Issue 2 17/07/98