VTD48EH020T040A00 Vicor

USER GUIDE UG:014 VI Chip VTM Evaluation Board Contents Page Introduction Introduction 1 This evaluation board offers a convenient means to evaluate the performance of the Vicor VTM current Features 2 multiplier. All evaluation boards include sockets for easy plug-and-play insertion and removal of through-hole components and wires. The board provides lugs for power connections, connectors for Board Description 3 easy PRM-VTM evaluation board interconnects and Kelvin voltage-measurement test points of all pins of the VTM. Please refer to the appropriate VTM data sheet for performance and operating limits, available General Components 4 for downloading at www.vicorpower.com. Test Points and Sockets Description 5 Schematic 6 Assembly Drawings 8 Bill of Materials 9 PRM & VTM Evaluation Boards 10 Stand-Alone Operation vs. PRM-VTM Operation 10 PRM-VTM Non-Isolated Remote Sense 10 Paralleling 11 Push-Pin Heat Sink Installation 11 Using the VTM Evaluation Board for Reverse Operation 11 Part Ordering Information 11 IMPORTANT NOTICE: Please read this document before setting up a VTM evaluation board. This user guide is not comprehensive and the operator should not substitute it for common sense and good practice. The following procedures should be followed during operation: nnWear approved safety glasses when testing electronic product. nnProvide strain relief for wires and secure the board on the test bench to avoid displacement. nnRemove the power and use caution when connecting and disconnecting all test probes and interface lines to avoid unintentional short circuits and contact with hot surfaces. nnNever attempt to disconnect the evaluation board from a PRM evaluation board while power is applied. This system is not designed to demonstrate the hot-plug capability. UG:014 Page 1Contents All VTM evaluation boards arrive with the following contents. (The user guide can be downloaded from www.vicorpower.com.) nn1 x VTM Evaluation board nn1 x VI Chip push-pin heat sink nn2 x VI Chip push pins for heat-sink installation nn1 x Hardware kit nn2 x Through-hole mating connectors nn1 x Through-hole 22F input capacitor Features 1. Input filtering: ceramic capacitors and sockets for installation of through -hole aluminum electrolytic capacitor 2. Output filtering: ceramic capacitors 3. Oscilloscope probe jack for output voltage signal measurement 4. Kelvin test points for measurement of input voltage, output voltage and all signal pins of the VTM 5. Sockets for each test point for easy installation of through-hole components and solid wires to facilitate wiring to external circuitry and test equipment 6. Input and output lugs for power supply and load connections 7. Input power and signal connectors for testing with PRM module 8. Provisions for non-isolated remote-sense operation with PRM evaluation board a. Provision to inject network analyzer signals b. 2512 resistor footprint for installation of zero-ohm resistor to break the VTM isolation for non-isolated remote-sense operation c. Sense pins with local-sense resistors to +OUT and OUT UG:014 Page 2