5KP20A World Products

Transient Voltage Suppression Diodes Axial Leaded 5000W > 5KP series Pb e3 RoHS 5KP Series Description Uni-directional The 5KP Series is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. Features Bi-directional 5000W peak pulse Low incremental surge capability at 10/1000s resistance waveform, repetition rate Typical I less than 2A R (duty cycles):0.01% when V min>12V BR Agency Approvals Glass passivated chip High temperature junction in P600 package to reflow soldering AGENCY AGENCY FILE NUMBER Fast response time: guaranteed: 260C/40sec E230531 typically less than 1.0ps / 0.375, (9.5mm) lead from 0 Volts to BV min length, 5 lbs., (2.3kg) tension Excellent clamping Maximum Ratings and Thermal Characteristics O capability V @ T = V @25C (T =25 C unless otherwise noted) BR J BR A x (1+T x (T - 25)) Typical failure mode is J (T:Temperature Parameter Symbol Value Unit short from over-specified Coefficient, typical value voltage or current Peak Pulse Power Dissipation by is 0.1%) 10/1000s Test Waveform (Fig.2) P 5000 W Whisker test is conducted PPM (Note 1) Plastic package is based on JEDEC ammabilitfl y rated V-0 per Steady State Power Dissipation on JESD201A per its table 4a P 8.0 W D Infinite Heat Sink at T =75C Underwriters Laboratories and 4c L Peak Forward Surge Current, 8.3ms Matte tin leadfree plated IEC-61000-4-2 ESD Single Half Sine Wave Unidirectional I 400 A FSM 30kV(Air), 30kV (Contact) Halogen free and RoHS Only (Note 2) compliant ESD protection of data Maximum Instantaneous Forward Voltage at 100A for Unidirectional V 3.5/5.0 V lines in accordance with Pb-free E3 means 2nd F Only (Note 3) IEC 61000-4-2 level interconnect is Operating Junction and Storage Pb-free and the terminal EFT protection of data T , T -55 to 175 C J STG Temperature Range finish material is tin(Sn) lines in accordance with Typical Thermal Resistance (IPC/JEDEC J-STD- IEC 61000-4-4 R 8.0 C/W JL Junction to Lead Typical Thermal Resistance R 40 C/W JA Junction to Ambient Applications Notes: O 1. Non-repetitive current pulse , per Fig. 4 and derated above T (initial) =25 C per Fig. 3. J TVS devices are ideal for the protection of I/O interfaces, 2. Measured on 8.3ms single half sine wave or equivalent square wave, duty cycle=4 per minute maximum. V bus and other vulnerable circuits used in telecom, CC 3. V < 3.5V for single die parts and V < 5.0V for stacked-die parts. computer, industrial and consumer electronic applications. F F Functional Diagram Additional Infomarion Bi-directional Datasheet Resources Samples Cathode Anode Uni-directional 2015 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 11/20/15Transient Voltage Suppression Diodes Axial Leaded 5000W > 5KP series Electrical Characteristics (T =25C unless otherwise noted) A Maximum Maximum Maximum Breakdown Test Reverse Agency Part Part Clamping Peak Reverse Voltage V BR Current Stand off Approval Number Number Voltage Pulse Leakage (Volts) @ I I Voltage V T T R (Uni) (Bi) V @ I Current I I @ V R R C PP PP (Volts) (mA) MIN MAX (V) (A) ( A) 5KP5.0A 5KP5.0CA 5.0 6.40 7.00 50 9.2 554.3 5000 X 5KP6.0A 5KP6.0CA 6.0 6.67 7.37 50 10.3 495.1 5000 X 5KP6.5A 5KP6.5CA 6.5 7.22 7.98 50 11.2 455.4 2000 X 5KP7.0A 5KP7.0CA 7.0 7.78 8.60 50 12.0 425.0 1000 X 5KP7.5A 5KP7.5CA 7.5 8.33 9.21 5 12.9 395.3 250 X 5KP8.0A 5KP8.0CA 8.0 8.89 9.83 5 13.6 375.0 150 X 5KP8.5A 5KP8.5CA 8.5 9.44 10.40 5 14.4 354.2 50 X 5KP9.0A 5KP9.0CA 9.0 10.00 11.10 5 15.4 331.2 20 X 5KP10A 5KP10CA 10.0 11.10 12.30 5 17.0 300.0 15 X 5KP11A 5KP11CA 11.0 12.20 13.50 5 18.2 280.2 2 X 5KP12A 5KP12CA 12.0 13.30 14.70 5 19.9 256.3 2 X 5KP13A 5KP13CA 13.0 14.40 15.90 5 21.5 237.2 2 X 5KP14A 5KP14CA 14.0 15.60 17.20 5 23.2 219.8 2 X 5KP15A 5KP15CA 15.0 16.70 18.50 5 24.4 209.0 2 X 5KP16A 5KP16CA 16.0 17.80 19.70 5 26.0 196.2 2 X 5KP17A 5KP17CA 17.0 18.90 20.90 5 27.6 184.8 2 X 5KP18A 5KP18CA 18.0 20.00 22.10 5 29.2 174.7 2 X 5KP20A 5KP20CA 20.0 22.20 24.50 5 32.4 157.4 2 X 5KP22A 5KP22CA 22.0 24.00 26.90 5 35.5 143.7 2 X 5KP24A 5KP24CA 24.0 26.70 29.50 5 38.9 131.1 2 X 5KP26A 5KP26CA 26.0 28.90 31.90 5 42.1 121.1 2 X 5KP28A 5KP28CA 28.0 31.10 34.40 5 45.4 112.3 2 X 5KP30A 5KP30CA 30.0 33.30 36.80 5 48.4 105.4 2 X 5KP33A 5KP33CA 33.0 36.70 40.60 5 53.3 95.7 2 X 5KP36A 5KP36CA 36.0 40.00 44.20 5 58.1 87.8 2 X 5KP40A 5KP40CA 40.0 44.40 49.10 5 64.5 79.1 2 X 5KP43A 5KP43CA 43.0 47.80 52.80 5 69.4 73.5 2 X 5KP45A 5KP45CA 45.0 50.00 55.30 5 72.7 70.2 2 X 5KP48A 5KP48CA 48.0 53.30 58.90 5 77.4 65.9 2 X 5KP51A 5KP51CA 51.0 56.70 62.70 5 82.4 61.9 2 X 5KP54A 5KP54CA 54.0 60.00 66.30 5 87.1 58.6 2 X 5KP58A 5KP58CA 58.0 64.40 71.20 5 93.6 54.5 2 X 5KP60A 5KP60CA 60.0 66.70 73.70 5 96.8 52.7 2 X 5KP64A 5KP64CA 64.0 71.10 78.60 5 103.0 49.5 2 X 5KP70A 5KP70CA 70.0 77.80 86.00 5 113.0 45.1 2 X 5KP75A 5KP75CA 75.0 83.30 92.10 5 121.0 42.1 2 X 5KP78A 5KP78CA 78.0 86.70 95.80 5 126.0 40.5 2 X 5KP85A 5KP85CA 85.0 94.40 104.00 5 137.0 37.2 2 X 5KP90A 5KP90CA 90.0 100.00 111.00 5 146.0 34.9 2 X 5KP100A 5KP100CA 100.0 110.00 123.00 5 162.0 31.5 2 X 5KP110A 5KP110CA 110.0 122.00 135.00 5 177.0 28.8 2 X 5KP120A 5KP120CA 120.0 133.00 147.00 5 193.0 26.4 2 X 5KP130A 5KP130CA 130.0 144.00 159.00 5 209.0 24.4 2 X 5KP150A 5KP150CA 150.0 167.00 185.00 5 243.0 21.0 2 X 5KP160A 5KP160CA 160.0 178.00 197.00 5 259.0 19.7 2 X 5KP170A 5KP170CA 170.0 189.00 209.00 5 275.0 18.5 2 X 5KP180A 5KP180CA 180.0 200.00 221.00 5 292.0 17.5 2 X 5KP190A 5KP190CA 190.0 211.00 233.00 5 310.0 16.5 2 X 5KP200A 5KP200CA 200.0 222.00 246.00 5 329.2 15.5 2 X 5KP210A 5KP210CA 210.0 233.00 258.00 5 349.5 14.6 2 X 5KP220A 5KP220CA 220.0 244.00 270.00 5 371.1 13.7 2 X 5KP250A 5KP250CA 250.0 277.00 306.00 5 425.0 12.0 2 X For bidirectional type having V of 10 volts and less, the I limit is double. R R For parts without A , the V is 10% and V is 5% higher than with A parts BR C 2015 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 11/20/15