SC010M0470A3F-0815 Yageo

F0.5 F0.5 YAGEO CORPORATION ELECTROLYTIC CAPACITORS Low Impedance and Low ESR Suitable Miniature Aluminum SC for Motherboard Output Termination Electrolytic Capacitors 105C Single-Ended Lead Aluminum Electrolytic Capacitors For High Frequency Applications ELECTRICAL CHARACTERISTICS Operating Temperature Range : -40 ~ +105C Rated Voltage Range : 6.3 ~ 100V Rated Capacitance Range : 4.7 ~ 15000F Capacitance Tolerance : -20 ~ +20% at 120Hz, 20C DC Leakage Current (A) : I = 0.01CV or 3A whichever is greater. DESCRIPTION (After Rated Voltage Applied for 2 Minutes) Applicable for switching regulator of compurters, Dissipation Factor especially for high frequency W V (V) : 6.3 10 16 25 35 50 63 100 D.F. (%) : 22 19 16 14 12 10 9 8 MULTIPLIER FOR RIPPLE CURRENT When nominal capacitance is over 1000F, tan shall be added 0.02 to listed value with increase of every Frequency Coefficient 1000F. FREQUENCY (Hz) 50 120 300 1K 10K W V (V) : 6.3 10 16 25 35 50 63 100 ~4.7F 0.30 0.40 0.50 0.70 0.80 Impedance : Z(120Hz) Z - 25C / Z + 20C 4 3 3 3 3 2 2 2 5.6~33F 0.40 0.50 0.60 0.80 0.90 Z(120Hz)Z - 40C / Z + 20C 8 6 4 4 4 4 4 4 34~330F 0.60 0.70 0.80 0.90 0.95 Endurance : After the rated voltage has been applied at 105C for 3000 hours, the capacitors shall meet the 331~1000F 0.65 0.90 0.90 0.98 1.00 following requirements. 1200F Higher 0.85 0.90 0.95 0.98 1.00 If Dimension is Down Size, Endurance will be Less 1000 hours than Standard (a) Capacitance Change : Within 20% of Initial Value (b) Dissipation Factor: Not Exceeding 200% of Specified Value CASE SIZE 5x11 ~ 10x12 10x15 higher (c) Leakage Current: Not Exceeding the Specified Value LIFE 2000 3000 Shelf Life : After having been placed at 105C without voltage applied for 1000 hours, the capacitors shall meet the same requirements as Endurance. DIAGRAM OF DIMENSIONS Dimensions: mm D F d Rubber Stand-off 4.0 1.5 0.45 5.0 2.0 0.5 Vinyl Sleeve Rubber End Seal Vinyl Sleeve Rubber End Seal 6.3 2.5 (P.V.C) (P.V.C) 8.0 3.5 0.6 10.0 5.0 12.0 13.0 L 15Min. 5Min. L 15Min. 5Min. D0.5 D0.5 16.0 7.5 0.8 < D 20 D + 0.5 L 16 L + 1.5Max. 18.0 D 20 D + 1 L > 16 L + 2Max. D = 8 & 10 L + 2.5Max. 22.0 10.0 0.8 (1.0)61 CASE SIZE & PERMISSIBLE RIPPLE CURRENT OF STANDARD PRODUCTS D x L: mm CAP. (F) RATED VOLTAGE W V (SURGE VOLTAGE W V) 6.3 (8) 10 (13) 16 (20) 25 (32) SIZE RIPPLE ESR SIZE RIPPLE ESR SIZE RIPPLE ESR SIZE RIPPLE ESR 10 *4 x 7 40 2.000 5 x 11 50 0.550 47 5 x 11 150 0.450 56 5 x 11 100 0.630 5 x 11 150 0.420 68 5 x 11 150 0.420 6.3 x 11 200 0.370 100 5 x 11 150 0.420 5 x 11 200 0.370 6.3 x 11 250 0.220 120 5 x 11 200 0.370 6.3 x 11 250 0.320 8 x 11 300 0.200 150 5 x 11 200 0.420 6.3 x 11 250 0.320 6.3 x 11 300 0.220 8 x 11 550 0.140 220 6.3 x 11 250 0.320 6.3 x 11 300 0.220 8 x 11 550 0.140 *8 x 11 620 0.120 8 x 15 750 0.100 270 *6.3 x 11 300 0.220 330 *6.3 x 11 320 0.230 8 x 11 550 0.140 *8 x 11 620 0.120 *8 x 15 660 0.100 8 x 11 400 0.180 8 x 15 750 0.100 8 x 20 800 0.069 10 x 12 688 0.080 10 x 15 900 0.086 470 *6.3 x 11 440 0.180 *8 x 11 620 0.120 *8 x 15 730 0.093 *8 x 20 1000 0.067 8 x 11 550 0.140 8 x 15 750 0.100 10 x 12 800 0.085 *10 x 12 900 0.086 10 x 15 1050 0.064 680 *8 x 11 580 0.120 *8 x 11 640 0.110 10 x 15 1050 0.064 10 x 19.5 1100 0.039 8 x 15 700 0.100 10 x 12 800 0.085 820 8 x 20 750 0.085 10 x 15 1050 0.064 10 x 19.5 1100 0.044 10 x 19.5 1250 0.039 1000 *8 x 11 580 0.150 8 x 20 1080 0.065 *10 x 15 1140 0.043 *10 x 19.5 1160 0.047 *8 x 15 670 0.085 10 x 12 930 0.075 10 x 19.5 1250 0.039 *10 x 25 1310 0.042 8 x 20 800 0.069 10 x 15 990 0.085 13 x 20 1450 0.038 10 x 12 690 0.080 10 x 19.5 1100 0.050 1200 10 x 15 1000 0.064 10 x 19.5 1250 0.044 *10 x 25 1310 0.042 13 x 25 1600 0.029 13 x 20 1450 0.038 1500 *8 x 15 980 0.085 10 x 19.5 1450 0.039 *10 x 19.5 1200 0.045 *12 x 30 1750 0.032 *8 x 20 1070 0.051 13 x 20 1600 0.034 16 x 25 2000 0.028 *10 x 15 1070 0.055 10 x 19.5 1250 0.044 Note: 1. Ripple Current: (mA/rms) 105C, 100KHz 2. ESR: 100KHz / 20C ( Max.) 3. * Down Size: 1000 Hours less than standard