Gear Tooth Speed Sensors GS1005 GS1007 Sensors Hall Effect gear tooth speed sensor with adjustable anodized aluminum housing Description The GS1005-GS1007 series gear tooth speed sensors are Hall Effect devices designed for use in applications where ferrous edge detection/near zero speed sensing is needed. They provide a sinking current output. Features Typical Applications From near zero speed up to 15 kHz sensing capability Speedometers 10 bit dynamic threshold direction offers: Anti-lock braking systems - Automatically adjusting magnetic range Exercise equipment - Self-compensating to target geometry CNC machine tools Compatible with unregulated power supply RoHS compliant IP67 Typical air gap of 1.5 mm* Environmental Specifications Vibration Sinusoidal, 15 g max from 40 Hz to 2 kHz Mechanical Shock Resistance 50 g Maximum Speed Detection 15 kHz Operating Temperature (GS100501) -40 C to 105 C (-40 F to 221 F) Operating Temperature (GS100502, GS100701) -40 C to 125 C (-40 F to 257 F) Storage Temperature -40 C to 125 C (-40 F to 257 F) Ingress Protection IP67 Electrical Specifications Operating Supply Voltage 5 to 24 VDC Maximum Input Voltage 30 VDC Maximum Reverse Voltage 24 VDC Supply Current 3 mA typ., 6 mA max Output Sink Current 20 mA max Recommended Pull-Up Resistor See chart Mechanical Specifications Housing Material Anodized Aluminum Maximum Installation Torque Limit 5.65 Nm (50 in lb) on threads Operating Air Gap / Sensing Distance* 1.5 mm (0.06 ) * With recommended target type see drawing Sensor Orientation Not sensitive Products Part Number Thread Leads Connector GS100501 M12-1 12 mm, 4-pin circular mating connector, type IEC 60947-5-2 GS100502 M12-1 20 AWG x 1 m GS100701 15/32 -32 20 AWG x 1 m www.cherryswitches.com Page 1 of 2, Last update 2015-12-15, Specifications subject to change without notice.Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k Open Collector Sinking Block Diagram Dimensions mm (inches) GS100701 GS100501 GS100502 Installation For best results, we recommend targets made from low carbon cold rolled steel. Other factors that influence sensor performance include gear tooth height and width, space between the teeth, shape of the teeth and thickness of the target. As a general guideline, consider a target with minimum parameters as shown below. Note that smaller dimensions may work, but testing for the application is required. Tooth Height Tooth Width Distance between Target Thickness Teeth 5.0 mm (.200 ) 2.5 mm (.100 ) 10 mm (.400 ) 6.35 mm (.250 ) www.cherryswitches.com Page 2 of 2, Last update 2015-12-15, Specifications subject to change without notice.