Magnetic Proximity Sensors (Hall Effect) MP1005 - MP1007 Sensors Solid state magnetic proximity sensor with electrical immunity protection Description The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output. Features Typical Applications Solid state reliability Door position & interlock Stable output over operating temperature range Limit switch Compatible with unregulated power supply Flow/speed South pole activated Home security Open collector (sinking or NPN) output can be used with bipolar or Pedal switch CMOS logic circuits with suitable pull-up resistor RoHS compliant IP67 Environmental Specifications Operating Temperature (MP100502) -40 C to 85 C (-40 F to 185 F) Operating Temperature (MP100701) -40 C to 150 C (-40 F to 302 F) Storage Temperature (MP100502) -40 C to 85 C (-40 F to 185 F) Storage Temperature (MP100701) -40 C to 150 C (-40 F to 302 F) Ingress Protection IP67 Electrical Specifications Operating Supply Voltage 5 to 24 VDC Supply Current 4.1 mA typ., 7.5 mA max. Output Current (Sink) 25 mA max. Output Off Voltage 30 VDC Maximum Input Voltage 30 VDC Maximum Reverse Voltage 30 VDC Recommended Pull-up Resistor See chart Mechanical Specifications Housing Material Aluminium Maximum Installation Torque Limit 50 in lbs on threads Turn on / off 245 Gauss / 60 Gauss Products Part Number Housing Color Termination MP100502* Red 20 AWG x 1 m MP100701 Black 20 AWG x 1 m *Not commonly stocked please contact the factory or your distributor. www.switches-sensors.zf.com ZF Electronics Systems Pleasant Prairie, LLC (ZF) acquired the rights to the CHERRY branded switches and sensors in 2008. Although ZF divested its interest in the CHERRY name in 2015, the switches and sensors remain unchanged and are now sold under the ZF brand. Page 1 of 2, Last update 2017-12-14, Specifications subject to change without notice. Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k Open Collector Sinking Block Diagram Dimensions mm (inches) MP100502 MP100701 15/32-32 UNS-2A THREADS BLACK ALUMINUM www.switches-sensors.zf.com ZF Electronics Systems Pleasant Prairie, LLC (ZF) acquired the rights to the CHERRY branded switches and sensors in 2008. Although ZF divested its interest in the CHERRY name in 2015, the switches and sensors remain unchanged and are now sold under the ZF brand. Page 2 of 2, Last update 2017-12-14, Specifications subject to change without notice.