Ethernet Smart Cable UM020705-1012 User Manual Introduction Zilogs Ethernet Smart Cable, part number ZENETSC0100ZACG, allows you to connect Z8 Encore , Z8 Encore XP , ZNEO and eZ80Acclaim development boards to a Zilog Developer Studio II (ZDS II) host system using an Ethernet connection. This user manual provides instructions for installing the Ethernet Smart Cable hardware. Instructions are also provided for Ethernet-equipped host PCs that are not network-con- nected. After the Ethernet Smart Cable is connected, proceed with debugging as described in the documentation specific to your development kit. Kit Contents To determine the contents of your kit, refer to the Ethernet Smart Cable Packing List (PAK0019), a paper insert included with your kit. Software and Hardware Requirements The requirements for using the Ethernet Smart Cable are: A host PC with ZDS II v4.10.0 or later for Z8 Encore , eZ80Acclaim , or ZNEO. To determine ZDS II requirements for your host system, refer to the quick start guide for your specific development kit. The latest version of ZDS II is available as a free down- load from the Zilog Store. An available 10/100 Mbps Ethernet connection. Note: If you are using ZDS II eZ80Acclaim versions earlier than 4.10.0, see the Using the Ethernet Smart Cable on ZDS II eZ80Acclaim Versions Earlier than 4.10.0 section on page 11. Copyright 2012 Zilog , Inc. All rights reserved. www.zilog.comEthernet Smart Cable User Manual Supported Target Environments The supported target environments are described in the following table. System Clock Power Supply Minimum Maximum Minimum Maximum Current* Development Board Z8 Encore 32 kHz 20 MHz 2.7 V 3.6 V 2 mA ZNEO 10 kHz 20 MHz 2.7 V 3.6 V 2 mA eZ80Acclaim 5 MHz 50 MHz 3.0 V 3.6 V 2 mA Note: *Add this Ethernet Smart Cable current as a requirement for your targets power supply. Installing the Ethernet Smart Cable The Ethernet Smart Cable is optimized for use on an Ethernet network in which a dynamic host configuration protocol (DHCP) server assigns IP addresses. The following sections provide instructions for connecting the Ethernet Smart Cable to a DHCP-based network, or directly to an Ethernet-equipped host PC. The Ethernet Smart Cables factory default settings include: DHCP enabled IP address: 192.168.1.50 (this address will be different if a DHCP server is available to assign an address) Subnet mask: 255.255.255.0 Gateway: 192.168.1.254 No password required If you need to change the cables factory default settings, follow the steps described in the Changing the Default Settings of the Ethernet Smart Cable section on page 8. When a DHCP server is unavailable, the Ethernet Smart Cable defaults to Note: using IP address 192.168.1.50. If your network uses static IP addresses on a different subnet, connect the Ethernet Smart Cable to a stand-alone PC con- figured as described in the next section. UM020705-1012 Page 2 of 13